How do I get rid of Ford Ranger cluster?
- There are 4 bolts along the bottom.
- Remove the metal knee bolster panel.
- Pull these 2 screws out and the 3 on the top part of the gage cluster.
- Unscrew the 2 bolts holding the radio/HVAC facia.
- Now remove the piece surrounding the gage cluster so that it looks like this:
- Unscrew the gage cluster and pull it out.
How do you replace instrument cluster?
How Do You Replace The Instrument Cluster?
- Set the parking brake.
- If your gear shifter is on the steering column, move it down to the lowest setting possible.
- Tilt the steering wheel as low as you can.
- Remove the dashboard panel in front of the instrument cluster.
- If necessary, disconnect the wires behind the panel.
What to do if your dash light does not work?
#Test the dashboard light bulbs. If the fuses are working properly, check for a blown bulb in the dashboard. Following the manufacturer’s instructions, disconnect the battery while working on the dash, remove the faceplate covering your vehicle’s dashboard gauge panel. Remove the screws holding the plate on. Carefully remove the faceplate.
What’s the best way to replace a burned out Dashboard Light?
Twist the bulb socket a quarter turn and pull straight out. Swap in a new bulb for your instrument panel lights. You’ve probably replaced burned-out headlights and taillights yourself. But if you’ve backed away from replacing burned-out dashboard lights because you thought the job was too complicated, you’re now out of excuses.
Where are the lights on the dashboard located?
Most vehicles have a dashboard lights control switch that will dim the dashboard lights, as well as turn them off. Check the control switch, which should be located on the console near the steering column or part of the headlight switch. Tail lights and dash lights are connected through the tail light (and/or brake light) fuse.
Where is the fuse on the dash light?
The fuse box may be under the hood, or near the floor, near the brake pedal, or there may be two fuse boxes in both places. Refer to the diagram on the fuse box cover to locate the correct fuse. Replace the dashboard light fuse if necessary. Note: also check if the tail lights are working.