What is the crank holder tool on a Volvo?
B230F Crank Holder Tool-Method 1. [Don Foster] Here is the design for the tool used to secure the crank pulley to remove the bolt while changing the timing belt. [Editor’s Note: You can purchase this tool number 5284 from Volvo dealers and from IPDfor about US$39; see the FAQ section on Timing Belt Tips]
Is the CTA tools 2864 cam locking tool compatible with Volvo?
CTA Tools 2864 Cam Locking Tool – Volvo is designed to be used for alignment of the cam and crankshafts. It also allows correct installation of the camshafts with the cam cover. This kit services Volvo 850, 960, S40, S70 and S90 models. Heavy-duty construction allows for strength and durability.
What kind of tool set is compatible with Volvo?
ARES 15010 – Camshaft, Crankshaft, and Timing Alignment Master Tool Set for Volvo – Deep Counter-Weighted Sockets for Increased Torque – Correctly Install Camshafts with Cam Cover In Stock. In Stock. ABN Camshaft Locking Tool, Crankshaft Tool, Timing Tool Alignment Kit, Cam Lock Tool Set – Compatible with Volvo In stock. In stock. In Stock.
When do you need a Volvo camshaft locking tool?
If you’re doing a full-out head gasket replacement or CVVT/VVT hub or major timing work, this will not “cut the mustard” as you need the full kit “Volvo Cam/Crank Alignment Tool Kit – CTA 2863” or if you’re removing the cam tower (valve cover)… which I ended up purchasing in addition or you’ll definitely break something.
What kind of wrench does a Volvo use?
Volvo offers a special tool number 5411 used with an angled torque wrench to tighten these nuts to 30 Nm or 22ft-lbs. It looks like an 13mm open end wrench on one end with a 1/2″ drive hole on the other for the torque wrench, which is held at a 90 degree angle to the tool while tightening.
What kind of tools do you use on a Volvo B6304?
B6304 Cam Cover Compressor. [Tips from Nathan Gundy] A good (and cheap!) solution to the volvo cam squeeze tools on B6304 engines is to use two 2 inch wide by 1 inch thick by 1 foot long(or so) pieces of hardwood to go across the cam cover. Hold these pieces with 4 four-inch C clamps, rooted just under the cam cover on the head.
What kind of clamps do you use on a Volvo?
Hold these pieces with 4 four-inch C clamps, rooted just under the cam cover on the head. As you tighten the clamps down evenly, the cover will squeeze down the cams so you can safely put in all 48 cam cover bolts. Be sure to use hardwood; a lighter wood would probably crack, as it requires pretty strong pressure.