How to turn off the anti skid warning message on Volvo S40?
How do you turn off the anti skid warning message on volvo S40 How do you turn off the anti skid warning message on volvo S40 – Answered by a verified Volvo Mechanic We use cookies to give you the best possible experience on our website.
What do the warning lights on the dashboard mean?
Only a flashing red light means pull over immediately. There are three dashboard light colors on most dashboards: yellow, red, and orange (and, occasionally, blue or green). The most severe alerts are displayed in red or orange.
Why is the key light flashing on my Honda Odyssey?
She said that the ‘key’ light (immobilizer) on the dash was flashing after each attempt, which she didn’t remember seeing before. On a whim, I had her go inside and get the valet key. She did, and it started right away with the valet key. She tried again with her regular key and it started then too.
Why does my car not start when I Turn on the key?
This feature is not available right now. Please try again later. One possible reason your car wont start is a bad connection. This is one of those things that is often over looked until after the battery or starter or alternator have been replaced or all of the above. if this happens to you check your battery connections. Loading…
Is there a problem with my Volvo S40?
4,616 satisfied customers Volvo S40: have a problem with a built 2006 Volvo S40 Diesel have a problem with a built 2006 Volvo S40 Diesel 1560 cm Appears ANTI-SKID SERVICE REQUIRED. This message often occurs when CAN temperature is above 30 degrees Celsus and with it I reduce engine powe…
What to do about a Volvo V50 skid?
Hope this reply is not to late but this problem is common on v50. The problem is bad connection into the brain of the car which is located just above the passenger foot well below the carpet. Place a plastic cable tie on all the connections into this control unit and this will solve all problems.
How long does it take to repair Volvo anti skid system?
It’s also recommended to have an authorized repair facility perform a calibration of the unit. This should not take more than 5 minutes of the repair facility’s time. At this time, it’s also a good opportunity to have them clear any DTCs that are still left in the system.