How do you put an alarm in valet mode?
Turn the ignition off and remove the key once you set the valet mode. Some systems come with a toggle switch instead of a push button. If you locate a toggle switch, put the key in the ignition, turn the key and push the toggle to on. The steps for your system may differ. Check the owner’s manual for exact instructions on the valet mode.
Where is the push button on valet mode?
Locate the push button switch on your vehicle. According to Omega Vehicle Security the switch usually sits somewhere under the dash on the driver’s side. Put the key in the ignition and turn to the “on” position. Press down the valet button for five seconds. Check the LED light on your alarm system while continuing to press the button.
Where is the valet switch on a car?
Typical locations for valet switch: Under the driver’s side dash (mounted in the under-dash covering trim panel or wire-tied to a harness) Mounted in the driver’s side kick panel. Mounted in the steering column plastic housing.
Where is the alarm switch on a Omega car?
According to Omega Vehicle Security the switch usually sits somewhere under the dash on the driver’s side. Put the key in the ignition and turn to the “on” position. Press down the valet button for five seconds. Check the LED light on your alarm system while continuing to press the button.
How do you turn off the valet switch?
Press and hold the valet pushbutton switch or turn the valet switch to the off position. The system will remain in the valet mode. To return to normal operation make sure the ignition is in the on position, press and release the pushbutton switch or turn the valet switch to the on position. NOTE: Always remember to exit the valet mode.
How can I put my car in valet mode?
To use the valet mode, the system must first be disarmed either by using your key chain transmitter, or by activating your personalized manual override code. Enter the vehicle and turn the ignition key to the on position. Press and hold the valet pushbutton switch or turn the valet switch to the off position.
Where to find the valet or programming switch for?
Typical locations for valet switch: Mounted in the driver’s side kick panel. Mounted in the steering column plastic housing. Behind a fuse block door or access panel. Low in the center console in the back of a pocket. Along side of the fuse block. In the glove compartment.
Where can I get a new valet button?
If you bought a used car that has a valet switch or button most likely you can order a new remote. Look under the dash for a plastic box (the receiver or brain of the system) and use the Brand and Model name printed on it to search for the correct replacement aftermarket key fob remote transmitter.