Where does the crank sensor get power from?
The crankshaft sensor in modern passenger vehicles runs on 12 volts of DC power. The sensor should receive this power any time that a driver turns the ignition to the “ON” position.
How do you test a 3 wire crank sensor?
How To Test, a Three-Wire Sensor:
- First, identify the power, ground, and signal wires using your vehicle repair manual.
- Have your helper turn the ignition key on, but don’t start the engine.
- Touch the black probe on your meter to ground and the other probe to the power wire.
- Have your helper crank or start the engine.
What is the wiring diagram for a Volvo S60?
VOLVO S60 (11-) WIRING DIAGRAM 2011 TP 39203202… 2. Damage or malfunction of the SRS/SIPS bag/IC system. Work involving the SRS/SIPS bag/IC systems or other components in the vehicle that may affect the SRS/SIPS bag/IC systems must always be performed by an authorized Volvo workshop.
Where is the PNP switch on a Volvo S60?
Please try again later. Adam gives a quick DIY on how to replace the Automatic Transmission Position Switch, aka Neutral Safety Switch, aka PNP Switch located on the transmission for any 01-07 S60/V70/XC70 automatic, XC90 2.5T, S80 5cyl 04-06. Trans fault code 0039 is a common indicator of a faulty PNP switch. Loading…
What are the sensors on a Volvo S60?
Oil pressure sensor 7/15 Front heated oxygen sensor, Diesel TP39203202 S60 (11-) Page 256 Left-hand rear ABS sensor 7/73 Coolant level sensor 7/74 Fluid temperature sensor, automatic transmission 7/57 Right-hand rear ABS sensor 7/81 Pressure sensor, intake manifold, 4-Cyl.
Where are the fuses located on a Volvo S60?
Fuse Electrical distribution rail/box G. Component location Audio The end of the manual contains a section that Service/diagnostics describes component appearance and location in Contact reel numerical order. Meter Ignition component/shunt Optics Ground connection Branching point Connector TP39203202 S60 (11-)