How do you turn the key on a Volvo Car?
Get into the car and lock all doors. Insert the key and turn it from the insertion position (position I) to the “on” position (position II – not the “start” position) five times. In other words, all the dash lights come on, but the engine doesn’t start. When you turn the key to ON the fifth time, leave it there.
What to do if your Volvo keyless entry doesn’t work?
Get new batteries if the above doesn’t work, and try it again. If you already have new batteries in the remote, then proceed to the next step. Press and hold down the odometer reset button. Turn the ignition switch to the RUN position. Release the odometer button while the service reminder light (SRL) flashes.
How many times do you insert the key in a Volvo S40?
Insert the key and turn it from the insertion position (position I) to the “on” position (position II – not the “start” position) five times. In other words, all the dash lights come on, but the engine doesn’t start. When you turn the key to ON the fifth time, leave it there. You have 10 seconds to perform this whole step.
Do you need a remote to lock a Volvo?
If your alarm doesn’t arm when you lock the car with the remote control, try locking with the remote with two rapid-succession presses. Australian Volvo models from ’93 to ’98 do not use Volvo remotes; they use a different brand. The remotes aren’t owner-programmable and must be programmed at the dealership.
Why does my car key not go into the ignition?
As dirt is the major reason for the key not getting into the ignition, chances are that a few fragments might have stuck to the pins of ignition cylinder. Insert the key into the port as much you can and softly slide it back out.
What to do if your car key is damaged?
Coupled with a lack of maintenance, it increases the probability of keys being damaged. Once the key is physically damaged, you will need a locksmith to cut a new car key using the key code registered to your vehicle. Simply duplicating an existing car key will result in a copy of your existing issue. Signs of a damaged car key
Why is my alarm not working on my Volvo?
If the alarm module doesn’t provide the ground to start relay then the relay doesn’t provide feed to starter solenoid and no cranking results. Usually locking the car and then unlocking it should reset the alarm. The alarm module is also the door lock, fuel cap unlock, trunk lid latch, and interior light module.
How do you turn off the ignition on a Volvo?
Turn the ignition off. If your alarm doesn’t arm when you lock the car with the remote control, try locking with the remote with two rapid-succession presses. Australian Volvo models from ’93 to ’98 do not use Volvo remotes; they use a different brand. The remotes aren’t owner-programmable and must be programmed at the dealership.