How do you reattach a throttle cable?

How do you reattach a throttle cable?

Push the new cable through the firewall and into the engine compartment. Step 2: Hook the new cable up to the accelerator pedal. Slide the new cable through the slotted hole in the accelerator pedal. Step 3: Reconnect the throttle cable to the retaining bracket.

What happens if your throttle cable is loose?

When there is excess slack or the cable is too tight, this can cause intermittent delays in throttle response relative to pressing down on the accelerator pedal. This can cause more throttle to be applied unintentionally, creating a dangerous situation.

How much does it cost to replace an accelerator cable?

How much does an accelerator cable cost? It’s not that hard of a job, most of the cost is in labor. Expect prices to start at $165 and go higher than $300.

How do I know if my throttle cable is loose?

Signs of a bad accelerator cable

1. The pedal feels stiff or hard to depress.
2. The pedal sticks and does not release normally.
3. There is slack in the pedal’s movement.
4. There is a rough or abnormally low idle.
5. The engine stalls.
6. There is a delay in response when you push the pedal down.

How is the throttle cable disconnected from the accelerator pedal?

Step 3: Pull the throttle cable through the firewall. Pull the new cable from the engine compartment into the interior. Step 4: Disconnecting the throttle cable from the accelerator pedal. Typically, the throttle cable is disconnected from the accelerator pedal by lifting up on the pedal and sliding the cable through the slotted hole.

How do you replace the throttle cable in a car?

Step 1: Push the new cable through the firewall. Push the new cable through the firewall and into the engine compartment. Step 2: Hook the new cable up to the accelerator pedal. Slide the new cable through the slotted hole in the accelerator pedal. Step 3: Reconnect the throttle cable to the retaining bracket.

How can you tell if throttle valve cable is tight?

Have your helper sit in the driver’s seat and push the gas pedal to the floor. You will see the throttle linkage move all the way in one direction. This is called wide open throttle (WOT). Now with the throttle wide open, test the tautness of the throttle linkage. The cable should be tight with the housing extended, without any slop.

How to test the tautness of the throttle linkage?

Have your helper sit in the driver’s seat and push the gas pedal to the floor. You will see the throttle linkage move all the way in one direction. This is called wide open throttle (WOT). Now with the throttle wide open, test the tautness of the throttle linkage.