Why does my light work but not my fan?
If your ceiling fan stopped working but the light still works, check for a humming sound. This could be indicative of a blown motor capacitor, which is often caused by overheating. While inspecting the motor housing, look for a small black box connected to the pull cord.
What will you do if the fan does not oscillate?
How to Fix an Oscillating Fan
- Unplug the fan before any repairs are made.
- Take off the grill of the fan.
- Check the motor housing, shaft, blades and grill to see if they need to be cleaned.
- Check the set screw for any wear or damage.
- Check the motor housing and gear assembly.
What to do if fan stops working?
Floor Fan Stopped Working? Your Troubleshooting Guide
- Check the Cord. It sounds simple, but your first step should be to make sure the cord is securely plugged in.
- Check Your Circuit Breaker.
- Check for Power to Your Outlet.
- Check the Fan Fuse.
- Replace the Cord.
- Clean the Fan.
- Grease the Motor.
- Call Customer Support.
What to do if your Honda fans are not working?
Honda Fans not working? DO this easy check First! If your Honda Fans aren’t working it can be easy repair. I found that both the radiator fan and the AC fan weren’t working. or replace the fans, relays, temperature switch or even the fuses. The temperature switch is an easy repair and it’s even easier to replace.
Why is my Ceiling Fan not working properly?
A ceiling fan can stop working properly for a variety of reasons. We show you how to deal with a fan that doesn’t work at all because it isn’t receiving electrical power. Then we move on to other types of fan problems, such as wobbling, humming, and failure to turn properly.
Why is the fan not working on my Mazda 3?
The fan wiring is some of the more vulnerable wiring in your 3. You can test the voltage going from the fan relay to the fan itself. If it is getting 12+ volts, the fan should be coming on. But if it’s not, which means the fan has gone bad.
What to do when your heater fan stops working?
Fuse Good Relay (fan speed under hood) on firewall replaced Still no power getting to blower motor (purple wire) Mechanic found the harness plugging into the fan switch in the dash had melted. Unplug and take a look at yours. A.C. and heat blower now work. I was surprised the meltdown in harness dident blow any fuses 3 people found this helpful.