How do you reset the engine service required on a Volvo v70?
Press and hold the trip computer while turning your key to position two. The center arrow will flash red three times. On the third flash, you will let go and an alert will note that you just reset your service light.
How do you reset the engine service required on a Volvo v50?
Simply your car requires a service. To reset the service counter. press and hold the trip odometer resert button, then turn the ignition switch to position 2 within 2 seconds.
How do you reset the check engine light on a Volvo xc90?
Turn the Volvo’s ignition key to the “II” position in the ignition. Wait for the light on the diagnostic tool to stop flashing. The codes on your Volvo’s electronic control unit should be cleared at this point and the check engine light will reset itself.
What does engine system service required?
The Engine System Service Required is a service interval indicator. The engine check light coming on will mean you have a fault. You can simply re-set the Engine System Service Required by carrying out a simply re-set. Button A is located at the bottom and to the left of your speedo.
Should Dstc be on or off?
DSTC ON indicates that all system functions are active. This function helps maintain directional stability, for example when cornering, by braking one or more of the wheels if the vehicle shows a tendency to skid or slide laterally. This is one of DSTC’s permanent functions and cannot be switched off.
When does engine system service required come up?
A few days after the service a message came up: Engine System Service Required. I went back to the garage and the mechanic tried to reset it by pushing in the trip button whilst turning the key. During this time code 042 was displayed. The message reset but kept reappearing on starting the engine.
How to reset the ” engine system service required ” light?
If it says time for scheduled maintenance that is the service light. You can not pull codes using the reset button, only clear the service reminder light. The procedure for resetting the service light is…key in position 2, be sure that you are in trip 1 (t1), shut car off. Release the button as soon as you see it flash.
What does the service required warning light mean?
Now, this light is mainly used to remind the driver to change fluids while the check engine light will show that a fault has been detected. As mentioned earlier, the service required light is mainly used to remind drivers to change the oil and filter. When the light illuminates, you should take the car to be serviced at your convenience.
What does it mean when your dashboard warning light is not working?
This light means that Forward Collision Mitigation (FCM) LDW and automatic high beam system are not available because of high or low temperature. This light means that the Forward Collision Mitigation System is activated or one of the sensors is changed. This light means that the sensor is covered, is dirty, or not working.