What does 164-11 mean on an ECM?
164-11 is defined as a injection actuation pressure system fault. It basically means the pressure is not what the ECM wants. It could be too low or too high. It takes 200 psi off from what the ECM wants to set this code.
Is there a 164-11 injection actuation fault?
Code 164-11 Injection Actuation fault. Idles ok, bucks and sputters when accelerate. I have ET software. When I do an actuation test, the actual pressure at high idle … read more I have a logged code that is 164-2 injector actuation pressure eratic.
What are the fault codes on a C7 engine?
Have a c7 cat with fault codes 164 and 42. Replaced wiring harness on engine and injectors. Still missing and smoking … read more Vocational, Technical or Tra… We have a Cat Engine on our 2005 C7 Engine. We took it to We have a Cat Engine on our 2005 C7 Engine. We took it to CAT repair plz … read more Auto Mechanics 1&2/diesel…
What is the injection actuation code for a C7?
Getting a code 164-2 (Injection actuation pressure signal erratic). New actuation pressure sensor and new engine harness from ecm to sensors. Can you point … read more I have a 2005 Ford 750 with a C7. Code 164-11 Injection Actuation
What is the code for Ford diagnostic trouble?
Refer to our Generic OBD II code list for definitions on all other Ford diagnostic trouble codes. P1000 OBD System Readiness Test Not Complete P1001 KOER Test Cannot Be Completed P1039 Vehicle Speed Signal Missing or Improper P1051 Brake Switch Signal Missing or Improper P1100 Mass Air Flow Sensor Intermittent
Can a check engine light set off an injector control sensor?
An illuminated Check Engine Light can also be set off by a wide variety of other issues, so having the computer scanned for trouble codes is highly recommended. Injector control pressure sensors are more commonly found on diesel engines, however they can also be found on vehicles equipped with gasoline engines.
What is the Flash code for a Caterpillar C7 engine?
Flash Code 55 signals that no detected faults have occurred since key switch was turned to the on position. Troubleshooting is not required for codes 35, 41, 47 and 55. Injection Actuation Pressure Control Valve fault. Code 18 Engine RPM Signal Fault.