Is there a westernstar that wont run spn625?
We got a 2013 westernstar That wont run the code is spn625… We got a 2013 westernstar… what engine??? PTCAN: MCM System ID/MCM_C01 Not Received or Stopped Arriving Are there any battery voltage faults (SPN 168/FMI ANY)? Yes; troubleshoot battery voltage faults first. No; Go to step 2.
How to troubleshoot 52.3 SPN 625 / FMI 9?
If the resistance is less than 5 Ω, repair the short circuit in the wires between pins 1 and 3 of the CPC #4 connector and pins 13 and 19 of the 21–pin MCM connector. Refer to “52.3.1 Verify Repairs” . Measure the resistance between pin 1 of the CPC #4 connector and ground. If the resistance is greater than 5 Ω, go to the next step.
What is the SPN code for FMI PID / Sid flash?
SPN FMI PID/SID PID/SID ID FLASH CODE FAULT DESCRIPTION 615 4 SID 155 1615 Reserved Monitoring Unit For Temperature Diagnostics, Circuit Failed Low MU_ISP_T_TBD1_SRL 615 3 SID 155 1615 Reserved Monitoring Unit For Temperature Diagnostics, Circuit Failed High MU_ISP_T_TBD1_SRH 615 4 SID 155 1615
Is there a way to repair a westernstar SPN?
Yes; repair as necessary. No; Go to step 11. Check ACM internal terminating resistor by measuring and recording the resistance across pins 10 and 20 of the ACM 21-pin connector. Is the resistance between 110 and 130 ohms? Yes; Go to step 12. No; replace the ACM. Disconnect the CPC connector #3.
Are there any problems with my Western Star truck?
The truck started out with a broken AC system straight from the factory. The expansion valve was bad and it was changed at the dealer under warranty. Here are some problems, complaints and things I have run into. The fan in the dash is horrible loud when it runs on a higher speed. The front and rear system fight each other.
What to do if your westernstar wont run code?
Inspect the CPC connector for corroded, unseated (pushed out) or damaged pins, bent or spread pins; inspect the connector seal for damage (signs of water or oil intrusion). Is damage present? Yes; repair as necessary.