What happens if SPN 132 FMI 11 MAF sensor fails?
If SPN 132 FMI 11 – MAF sensor calibration failed – Insufficient number of data points sets, engine conditions are not stable to accept MAF calibration 1. Check to ensure entry conditions were all met (if EOT or ECT become lower than 176 F, test will fail) 2.
What are the codes for the MaxxForce 11?
It has codes SPN 639 FMI 14, SPN 2000 FMI 9 and 19. Also 524285 14. I took this readings from the screen on the truck, because I can connect the scanner, but there is no data coming from the ecm. I checked the powers and grounds to the ecm OK. I checked the ohms at the terminals C and D of the diagnostic plug 57.5 ohms.
Why is my MaxxForce 11 engine not starting?
The engine could have a 731 code which will prevent it from starting and shouldn’t be started until the code is diagnosed. The code prevents the engine from starting to prevent possible engine damage. Without knowing engine codes, you can’t diagnose the no start.
What is the MAF sensor on a MaxxForce DT?
This article provides overall MAF sensor calibration information including how to record a MAF calibration for a MaxxForce DT, 9, or 10 snapshot for a case file and diagnostic steps for MAF calibration failures. The MAF calibration is used to measure the volume and density of air entering the engine at any given time.
What are the fault codes for MaxxForce 15?
International MaxxForce 15 (All Years) Fault Codes CODE DESCRIPTION SPN 27 FMI 0 EGRP fault: over temperature SPN 27 FMI 3 EGRP signal Out of Range HIGH SPN 27 FMI 4 EGRP signal Out of Range LOW SPN 27 FMI 7 EGRP does not agree with commanded posit
When did the International MaxxForce 15 come out?
First announced in 2009, it was put into production and placed into trucks by August 2011. However, this engine was very short lived due to its ability to not meet engine requirements that it was announced in September 2012 that it would be discontinued.
When did 2010 MaxxForce DT, 9 MAF sensor calibration apply?
View My Bookmarks2178 1241 Title: 2010 MAXXFORCE DT, 9 and 10 MAF SENSOR CALIBRATION Applies To: 2010 MAXXFORCE DT, 9, 10 CHANGE LOG DO NOT delete the CHANGE LOG Updated : 05/29/14 Author changed to Jaime Ochoa.