Is there a 2000 Intl DT466 low ICP valve?
Sn- 1htwnazr38j695117 … read more 2000 INTL DT466 LOW ICP. NEW IPR, NEW IPC, FULL FIELD IPR 2000 INTL DT466 LOW ICP. NEW IPR, NEW IPC, FULL FIELD IPR ONLY BUILDS 175PSI. JUST PUT NEW ORINGS ON ALL 6 INJECTORS.
What kind of ICP does a dt466e have?
Unable to build icp during crankingAlready replaced ipr Base engine oil pressure while cranking … read more Vocational, Technical or Tra… 2007 international 4700. DT 466e DLCII I6. Engine is missing 2007 international 4700.
What’s the fuel pressure on an international dt466e?
Pressure while cranking is around 890 psi. With the pump dead headed to a gauge it is 4000 psi. I have changed the icp sensor and the ipr valve. fuel pressure is around 60 psi while cranking with the needle on the gauge bouncing. Also have installed new fuel pressure regulator. I would have to by a computer to swap.
Is the IPR sensor on my dt466e good?
Pressure tested good, unhooked the IPR sensor and provided it with 12v and grounded it out, started and ran like a champ. Chasing down a loose connection to the ecm now. Was this answer helpful?
Where is the ICP sensor on a dt466e?
Try disconnecting the ICP sensor in the center of the fuel rail on the driver ‘s side of the engine . It is a 3 wire sensor . When disconnected , the engine light should come on but it will start and run on a default logic built into the ECM .
What makes a 2003 International 4300 sputter and Miss?
I have a 2003 International 4300 with a DT466. I just had all the O-rings on the injectors replaced along with the wiring harness that goes to the injectors. Now once the truck gets up to running temp it starts to sputter/miss. Truck runs GREAT cold but once warm gets worse.
Is the dt466e a 2001 International Truck?
Hi, I have a 2001 international truck with the DT466E. The truck was pulling hard up a hill when the warn/engine light came on and it lost power. It has codes 333 and 335. It starts with a wiff of eit … read more
Do you have a new IPR valve, new HPOP?
New IPR valve, new HPOP, all 6 new injectors, still low ICP. Pulled new HPOP off Have truck repair questions? Ask an Expert By continuing to use this site you consent to the use of cookies on your device as described in our cookie policy unless you have disabled them. I have a DT466E with low ICP pressure. New IPR valve, new… I have a DT466E…