What makes an international 4300 DT466 shut off?
Andy.I have an international 4300 dt466. it starts and stalls… 06 international 4300 dt466 shuts off while driving restarts after a minute or so. Several codes and seems worse when driven on wet roads. Codes are Sid1 fmi5 and so on for all 6 injectors Sid34 fmi4 … read more
What makes a 2003 International 4300 sputter and Miss?
I have a 2003 International 4300 with a DT466. I just had all the O-rings on the injectors replaced along with the wiring harness that goes to the injectors. Now once the truck gets up to running temp it starts to sputter/miss. Truck runs GREAT cold but once warm gets worse.
When did DT466 truck die and will not start?
(1) August 2015 truck was towed back to our place. One of the guys here said that he drained water out of the fuel and the truck started, but then it didn’t start next day so we called local mechanic and he checked electrical connectors and found that fuse in battery box was not making connection and shorted.
What to do with a 2005 International 4300?
Hi i have a 2005 international 4300 with a dt466 and has an no start situation. We have replaced the injector harness,valve cover gasket, icp sensor,idm with reprogramed ecm, icp pigtale (the one that goes from the external harness to the valve cover) and batteries.
Is the IH 4300 DT466 getting hard to start?
I have an 05 IH 4300 DT466 with 131K miles on it. I have had a small problem with it before, usually first thing in the AM. But now it doesn’t want to start no matter what time of the day it is. If its been sitting for any length of time it cranks and will finally start after about 45 seconds.
Where is the starter on a 2004 DT466?
If you start from behind the head and start feeling downwards and onto the bell housing you will see that it is mounted with one small bolt at about the 11 o’clock position . It is above the starter by about 12 inches for sure but right on top of the bell housing .
Why does my 2005 International 4300 not start?
It had several codes before we changed all of it but now there arnt any and it still wont start. before when we would crank it it would kinda sound like it was firing on a couple cylinders but only when cranking and it had a hazy blackish smoke coming from the exhaust.
Why does my 2004 DT466 engine not start?
I have a 2004 4300 international dt466 it cranks but no start. I have changed all sensors still nothing check fuel pressure injector orings im stuck. Engine position sensor shows up when u put computer on it. Where should I check for a broken wire maybe? Plug to sensor has power and sensor is good.
What kind of engine does an international 4300 have?
2006 International 4300 with a DT466 engine. The engine had 2006 International 4300 with a DT466 engine. The engine had low ICP and wouldn’t start a couple weeks ago. I pulled IPR valve, found … read more
Why is my DT466 getting hard to start?
Forget about it if the ambient temp was 50 degrees or less, absolutely nothing till cycling the key numerous times. Though the grid appeared fine I isolated the problem by running the truck through 4-6 cycles of the wait to start procedure depending on the temp.
Why is my DT466 so hard to start?
The exception to that is a wiring problem with the IPR valve, since system voltage drops significantly during cranking, the IPR valve is suseptable to malfunction because of low voltage during cranking even tho there is no defect with the valve itself.
What should off hand rpm be on DT466?
If it cranks don’t rev it unless you have a gauge to handle about 3000psi. Off hand should take close to 600psi to start. also you can pull the valve cover and apply shop air pressure into the rail and look for air bypassing the injectors.
What’s the fuel pressure on a 2005 International 4300?
After the rebuild it started up grea … read more 05 International 4300 DT466 5H121916- 300k plus mileage Crank no start. After we had to remove timing cover both parts due to cracks in air compressor mount area. Checked fuel pressure 35psi.
Why does my dt466e no start-fuel problem?
Got that all fixed. Realized that my primer pump would leak when I would pump it, replaced the entire assembly. Filled both filters, truck fired on the first try. Now today go to run a call, cranks and cranks wont start. Gave a shot of ether, fires but wont run on diesel.
What kind of engine does a 2005 International 4300 have?
I have a 2005 International 4300 with a DT466. The engine was just rebuilt. The “O” Rings on the sleeves had gone bad causing the coolant to go into the crankcase. After the rebuild it started up grea … read more 05 International 4300 DT466 5H121916- 300k plus mileage Crank no start.
Can a 2005 International shut off while driving?
I have a 2005 International with a DT466. The issue I’m having is without warning, while driving down the road the truck will lose power and then shut off. No engine light comes on, no codes in the Dash changed the fuel filter checked the fuses in the battery box, Checked the relays underneath the hood and replaced the camshaft sensor.
What should fuel pressure be in 2005 DT466?
You will see the pressure relief ball. It may be partially unseated by debris causing a drop in fuel pressure. Anyway, you will notice a compuchek fitting on the top of the filter housing cap. You plug in a fuel pressure gauge here to test your fuel pressure. Need 20 psi to start, 65 psi is normal running pressure.