When to remove cylinder liners on Detroit 60 diesel?
Cylinder Liner Assembly Removal on 2002-2006 Detroit Diesel 60 Series 12.7 + 14.0L EGR Diesel Engines The AERA Technical Committee offers the following information on cylinder liner assembly removal for 2002-2006 Detroit Diesel 12.7 & 14.0L EGR diesel engines.
What kind of lining does Detroit Diesel use?
First, an optimum composition (copper, tin and lead) lining is bonded to the steel back. A nickel barrier above the lining and the overlay serves to prevent tin migration. A soft lead overlay, 0.025 mm (0.001 in.) thick, provides run-in protection, and an initial wear surface.
What’s the bearing clearance on a Detroit Diesel engine?
Type PB-1 (blue) has a range of 0.1016-0.2286 mm (0.004 -0.009 in.). The plastic strip may be used for checking the bearing clearances as follows: Remove the bearing cap and wipe the oil from the bearing shell and the crankshaft journal to be checked.
Where is the weep hole on a Detroit Diesel?
A weep hole for each cylinder is drilled through the cylinder block exterior, into the cylinder bore area. This weep hole is located between the two D-shaped seal rings. It is used to determine if engine coolant is leaking past the upper liner seal, or if oil is leaking past the lower liner seal. See Figure “Weep Hole Plug Locations” .
What are the OTC Tools for Detroit Diesel engines?
The special pin on the 5882 fits into the cam timing hole on Detroit Diesel Series 60 engines for proper alignment. Crankshaft Alignment Tool (#5883) and Replacement Tip (#5883-1) – The OTC Crankshaft Alignment Tool ensures proper crankshaft alignment during camshaft timing inspection and service of Detroit Diesel Series 60 engines.
When do you remove the gear case cover?
Install the new front oil seal after the gear case cover has been installed to the engine. If necessary, remove the crankshaft front oil seal at this time. Refer to “1.8.2 Removal of Front or Rear Crankshaft Oil Seal (Gear Case Cover or Flywheel Housing Removed)” .
What are crank and CAM tools for Detroit Diesel engines?
New crankshaft and cam tools include a crankshaft seal and wear sleeve installer, an alignment tool and replacement tip, along with a cam gear alignment fixture, retaining tool and an alignment tool. Each tool is for use on multiple variants of Detroit Diesel engines.