Is there a charge for cat trouble codes?
There is no charge for this service, but standard message and data rates may apply. When I brought the truck new I got a laminated page with all the codes on it for the C12-15-16 and the E I will try and find it and post it on here later today.
When to troubleshoot code 35, 41, 47, 55?
Troubleshooting is not required for codes 35, 41, 47 and 55. Code 01 will not flash out. Some codes will limit the operation or the performance of the engine. Refer to the Diagnostic Flash Code chart for these codes. If the YELLOW lamp illuminates during engine operation and then shuts off, an intermittent fault may have occurred.
What are the fault codes for a caterpillar?
Caterpillar Fault Codes PID/SID FMI Fault Description 1 11 injector solenoid cyl#1 current below normal or open 2 11 injector solenoid cyl#2 current below normal or open 3 11 injector solenoid cyl#3 current below normal or open 4 11 injector solenoid cyl#4 current below normal or open
How to check the active code on a caterpillar truck?
All ACTIVE codes may be viewed using a Caterpillar electronic service tool or by performing the following procedure. Turn the Cruise Control ON/OFF switch OFF. 2. Move the SET/RESUME switch to either position. Hold that position until the YELLOW lamp begins to flash.
Can a C12 engine go bad on a truck?
From what I’ve heard about C12 CAT engines is they can go bad in many ways. Rebuild them and 1 week later they are scrap. The worst CAT engine ever, and replace it with a C13, I hear often. From what I’ve heard about C12 CAT engines is they can go bad in many ways.
How do you find a cat fault code?
Count the first sequence of flashes in order to determine the first digit of the diagnostic code. After a two second pause, the second sequence of flashes will identify the second digit of the diagnostic code. NOTE: Catfaultcodes.com indicates the potential effect on engine performance with ACTIVE fault codes.
What is a failure mode identifier ( FMI ) in cat?
A failure mode identifier (FMI) is a diagnostic code that informs the service personnel of the type of problem that has been detected within a circuit or system. CAT FMI Code List A module identifier (MID) is a diagnostic code that identifies the electronic control module that has diagnosed a fault.