How do you retrieve a Eaton Fuller fault code?
After 5 seconds, the Service light begins flashing two-digit fault codes. If no faults are active, the service light will flash code 25 (no codes). To Retrieve Inactive Codes: Turn key on. Turn the key off and on 4 times within five seconds ending with the key in the on position.
What is the no fault code on a Eaton transmission?
If no faults are active, the service light will flash code 25 (no codes). Two digit fault codes will be displayed in the gear display. Some vehicle may be equipped with a service light. Observe the sequence of flashes on the service light and record the codes.
What’s the best way to clear a fault code?
Clearing Fault Codes 1. Start with the key in the ON position. Turn the key OFF and ON six times within five seconds, ending with the key in the ON position. Note: If the codes have been successfully cleared, the service lamp will come on and stay on for five seconds. 2. Turn the key OFF and allow system to power down. OFF ON 2 TIMES OFF ON
How to clear a fault code in Autoshift?
Start with the key in the 6 TIMESON position. Turn the key OFF and ON six times within five seconds, ending with the key in the ON position. Note: If the codes have been successfully cleared, the service lamp will come on and stay on for five seconds. 2. Turn the key OFF and allow system to power down. 11 No ECU.
What is the hexadecimal fault value for Siemens?
Fault value (r0949, interpret hexadecimal): Only for internal Siemens troubleshooting. Note: Refer to r9999 for further information about this fault. r9999[0]: Fault number. r9999[1]: Program counter at the time when the exception occurred. r9999[2]: Cause of the FloatingPoint exception.
What are the fault codes for a fuel pump?
The fuel pump has shorted to a 12V circuit. #1 injector short to ground or open circuit. #1 injector shorted to a 12V circuit. #2 injector short to ground or open circuit. #2 injector shorted to a 12V circuit. #3 injector short to ground or open circuit. #3 injector shorted to a 12V circuit.
What is the FMI rating for Eaton Fuller?
FMI – Description 0 High – most severe 1 Low – most severe 2 Erratic, Intermittent, or Incorrect 3 Voltage Above Normal 4 Voltage Below Normal