How to troubleshoot an Eaton ultrashift plus fault code?
When troubleshooting an Inactive fault code, use the Fault Isolation Procedures to guide you to the wiring and connectors associated wi th that fault. Once PD Mode is activated, flex the wiring harness and connectors to attempt to recreate the fault.
What’s the No Code on an Eaton transmission?
If no faults are active, the service light will flash code 25 (no codes). Two digit fault codes will be displayed in the gear display. Some vehicle may be equipped with a service light.
When did the Eaton ultrashift 10 speed come out?
Discussion in ‘ Trucks [ Eighteen Wheelers ] ‘ started by giannid, May 16, 2018 . We’ve got a 2010 International 8600 with an Eaton Ultrashift 10 speed.
How to retrieve Eaton Fuller transmission fault codes?
Place the shift lever in neutral. Set the parking brake. Turn key on with engine off. Note: If the engine is already running, you may still retrieve codes; however, do not engage the starter if the engine stalls. To Retrieve Active Codes: Key on. Turn key off and on 2 times within five seconds ending with the key on.
What happens when a Eaton Fuller transmission fault occurs?
Fault is stored in HCM memory. If the fault occurs while moving, the operation mode goes into AutoShift only. Electric motor/generator Assist and Regeneration are disabled; however, the high-voltage relays remain powered. Transmission defaults start gear to 1st.
How to clear a fault code in Autoshift?
Start with the key in the 6 TIMESON position. Turn the key OFF and ON six times within five seconds, ending with the key in the ON position. Note: If the codes have been successfully cleared, the service lamp will come on and stay on for five seconds. 2. Turn the key OFF and allow system to power down. 11 No ECU.
How to check Eaton hybrid transmission fault code?
ABS Module configured to communicate on J1708 or analog instead of J1939. ABS Module reporting an Active fault. NOTE: Refer to the Eaton Hybrid Component and Connector Location for Connector Locations. STEP 1. Check for Active or Inactive fault code status.