Where are the DIP switches on a speedometer?
The speedometer comes with a 10 position DIP-switch on the back of the unit. All switches are preset to “ON” (ON=1; OFF=0). If you already know how many pulses your vehicle or sender will generate, please see the Calibration Table. Using the binary code (ones and zeros), set the DIP-switches and mount the speedometer in the dash panel.
How do you turn off the speedometer?
If your speedometer has rocker-type switches, de press the ap pro – pri ate end of the switch with a suit able tool (NOT a pen cil!) that is not likely t o break off in side the speed o meter. P ressing dow n at the top of the switch turns the switch ON, press ing in at the bot tom of the switch tu rns the switch OFF.
What should the DIP switch be set to?
This switch is always set to the “0” position for 0-3500 RPM readings. right bank is for setting the odometer to show either miles or kilometers. This switch must be set to “0” for miles, or “1” for kilometers. Hi my name is Andy !
How to set the cor rect Po Si tions on a speedometer?
To de ter mine the cor rect po si tions and set the cali bra tion switches, per form the steps in Fig ure 1. Notes –This pro ce dure can be used as written for both Eng lish and met ric speed om e ters. If your speedometer has rocker-type switches, de press the ap pro –
What to do if your speedometer reads other than 60?
Set speedometer switches 2 6 7 8 OPEN, all others closed. Drive vehicle at 60mph. If the speedometer reads other than 60, set switches per chart below. Speedometer Reading OPEN SWITCH Speedometer Reading OPEN SWITCH
How do you turn on the speedometer slide?
P ressing dow n at the top of the switch turns the switch ON, press ing in at the bot tom of the switch tu rns the switch OFF. If your speedometer ha s slide-type switches, slide them up or down as shown. See Fig ure 2. Ev ery ef fort has been made to keep the in for ma tion in this doc u ment cur rent and ac –
What kind of DIP switch do I Need?
I have a 2000 Freightliner Classic XL FLD120. Several years ago speedometer dip switches were change for recalibration after going to tall rubber. I am going back to low profile 24.5 tires and need to … read more
How to install a speedometer Hall effect sender?
Set all DIP-switches to the “ON” (#1) position. Install and wire the speedometer as shown earlier. 2. Drive a known course with a distance of up to 10 miles. Be sure the speedometer pointer DOES NOT exceed the maximum speed of the speedometer while traveling the course. Reducing your speed may be necessary to prevent damage to the speedometer. 3.