Can you tighten a steering gear?
Usually a hammer and blunt punch will loosen the locknut. The bearings should be adjusted to get a few inch-pounds of drag on the worm gear (steering wheel), but you can adjust it by tightening up to remove the play, then go just a smidgen tighter..and tigthen the locknut securely.
What causes sloppy steering?
Causes of loose steering The most common reasons for free play in the steering are looseness in the steering gear itself or looseness in one or more of the steering linkage sockets. If these linkages wear out, they become weak and allow play in the steering system and make the steering feel sloppy.
How to adjust ride height on a Freightliner?
I place one end of the stick against the bottom of the frame rail and adjust the height control valve until the opposite end of the stick is centered on the shock absorber bolt. That is all there is to adjusting your ride height control valves. It gets easier after a few times.
Which is the correct adjustment for steering gear?
Steering Gear Adjustments. The first adjustment is the input shaft / worm gear thrust bearing preload. The term input shaft and worm shaft indicate the same part, just different names. The second adjustment is the sector lash adjustment. Always use the manufacturer’s recommended procedures and specifications.
How tall is the front axle on a Freightliner coach?
My coach has the AS120 front axle which means the proper height is 10 inches, measured from the bottom of the frame rail to the center of the shock absorber bolt. The rear axle is the AD200-RS17/19 its ride height is 9 3/4 inches again measured from the bottom of the frame rail to the center of the shock absorber bolt.
What should I use to adjust my steering box?
Always use the manufacturer’s recommended procedures and specifications. This adjustment removes any worm shaft axial end play, while providing the least amount of resistance to shaft movement. This adjustment is measured using an inch pound torque wrench.