Can a MaxxForce truck have no oil pressure?
Ok, you probably have Maxxforce DT,9 or 10 series. Unscrew oil filter 3 or 4 turns so it’s completed unseated. Have some start up truck while you watch. Yeah it will be a mess but you will sure as hell know you have oil pressure and then you can be done with this and no for sure.
What makes a MaxxForce DT have no power?
I know if it is a epa10 and you block off the cross over tube on the back side of the engine it will cause the exhaust back pressure to go to high into like 60 psi or so and the engine will cut back fuel to the injectors. Making low boost and no power. 6 03-19-2019, 06:14 PM (This post was last modified: 03-19-2019, 06:16 PM by kuracnabiciklu .)
What to know about the 2013 N13 engine aftertreatment system?
2013 N13 Engine Aftertreatment System Components, and identify proper operation of the 2013 N13 Engine Aftertreatment System. Modules This course consists of this introduction and the following three modules: Engine Identification, Exhaust Gas Recirculation, and Aftertreatment Fuel Injection.
What kind of oil filter does a MaxxForce DT have?
Hmm, those do not have oil lines feeding the air compressor, direct oil feed through the block. Ok, you probably have Maxxforce DT,9 or 10 series. Unscrew oil filter 3 or 4 turns so it’s completed unseated. Have some start up truck while you watch.
What’s the oil level on a MaxxForce IC DT?
Fuel transfer pump leaks at the shaft into the crankcase. Serviced our one ’11 IC DT today and the oil level was right on the money beforehand and the fuel filter appeared normal….. an amber color….. for 6K miles. None of our earlier Maxxforce buses have shown any abnormal fuel filter colors or oil levels.
Is the fuel filter on a MaxxForce covered by warranty?
None of our earlier Maxxforce buses have shown any abnormal fuel filter colors or oil levels. We have one unit with a bad driver but that’s not covered under the warranty……… unfortunately. If it doesn’t fit, FORCE it. If it breaks, well, it needed replacing anyway. Pullin’ wrenches for 45 years.