What is the ESA code for Peterbilt 387?
I have peterbilt 387 has code 148309 on esa and says no engine v can communication. The mileage does not show up on the engine v can communication. The… I have peterbilt 387 has code 148309 on esa and says no engine v can communication. The mileage does not show up on the cluster like normal.
Is the 2015 Peterbilt 579 having Regen issues?
I have a 2015 peterbilt 579. It is having regen issues. I I have a 2015 peterbilt 579. It is having regen issues. I pulled apart the decomposition tube ( I found def crystals at dosing valve. There was solidified def in the decomp tube, I cleared all that out … read more
Why is my Peterbilt 387 engine not working?
First check all your fuses for power on both sides with the key on and replace any with power only on one side. Look between your battery box and engine ECM for an inline fuseholder and blown fuse causing a loss of power to the engine ECM. Loss of power or ground causes the ECM not to power and communicate. This is more common to happen.
What kind of ECM does Peterbilt 387 have?
On a 2007 peterbilt 387 with a c13, I changed chassis electrical harness, power distribution box (fuse box) and attached wiring and also replaced ecm to truck harness. I cannot get any communication f … read more
When does an ISX fault code become active?
The pressure in the intake manifold exceeded the maximum allowable value for a given engine rated power. This DTC becomes active when the pressure in the intake manifold exceeds the maximum allowable value for a given engine power rating. ISF 2.8, ISF 3.8, ISB, ISC, ISL, ISLe , ISDe , QSB 3.3
What are the ISX fault codes for Cummins trucks?
ISF 2.8, ISF 3.8, ISB, ISC, ISL, ISLe , ISDe , QSB 3.3 A high signal voltage or an open circuit is detected in the coolant temperature sensor circuit. The ECM detects that the coolant temperature sensor signal voltage is greater than 5.13 VDC for more than 1 second.
When do I get the fault code 2398?
The fault code is set when the actual position of the drive changes the geometry of the turbocharger does not match the specified for more than 10 seconds. Error code 2398 Engine:
Can a 2009 Peterbilt 387 a / C quit?
2009 peterbilt 387 a/c quit. no power to switch on dash. Auto Mechanics 1&2/diesel… I am working on a 2003 peterbilt 387. When you turn the key I am working on a 2003 peterbilt 387. When you turn the key on the gauges swipe back and forth for a minute or two and then stop in the middle. All gauges do this except speedometer.
Is there a charge for the Pete 387?
There is no charge for this service, but standard message and data rates may apply. In my 08 389 the dash is controlled by a computer. Had some problems and Ptb. did an ESA update,no more problems. What’s ths ESA update? Don’t know anything about it, and I doubt werners retarded mechanics will either. From this article
What kind of VIN does Peterbilt Model 320 Vin have?
I have a 2013 peterbilt model 320 vin 3BPZL70X8EF241480 . I replaced the blower motor due to it being burnt up. Well iv installed in one does not work. Replaced resistor and switch pannel still not wo … read more I am working on a 2016 Kw 153310. I am having issues with I am working on a 2016 Kw 153310.