How much torque does a cat C11 have?
CAT C11 Torque 1050-1450 lb.ft 1400-1930 Nm @ 1200 rpm Click for CAT C11 engine manuals and specs. CAT C11 Dimensions approx: length 1297 mm, 51 in width 1050 mm, 48 in height 1217 mm, 49 in Click for CAT C11 engine manuals and specs. CAT C11 Weight approx: 1030 kg 2270 lb Click for CAT C11 engine manuals and specs.
How much torque do you need for a crankshaft?
In the same manner as Step a), tighten them to 53 N.m (5.3 kgf-m, 38.5 lb-ft). In the same manner as Step a) again, tighten them to 105 N.m (10.5 kgf-m, 76.0 lb-ft). Tighten cylinder head bolts (hex hole bolt) to specified torque. Install lower crankcase (1) to cylinder block. Apply oil to crankcase bolts before installing them.
How much torque does a cylinder head have?
Tighten cylinder head bolts (except hex hole bolt) to 53 N.m (5.3 kgf-m, 38.5 lb-ft) according to numerical order in figure. In the same manner as Step a), tighten them to 84 N.m (8.4 kgf-m, 61.0 lb-ft). Loosen all bolts until tightening torque is reduced to 0 in reverse order of tightening.
Where can I find the latest torque specs?
Find the most up-to-date torque spec listings in electronic format. FelPro-Only.com is your convenient source for advanced sealing information. It’s the place to learn and share “tricks of the trade,” find proper diagnosis and installation instructions, and enjoy easy access to parts reference.
What kind of injector do I need for cat C7 engine?
I have a 2003 Freightliner M2 with a Cat C7 engine. I removed the number 2 injector and iam trying to reinstall new injector. I need to know if there is a special tool to install it and is there anyth … read more
Do you need torque specs for C 13 ACERT?
I need the torque specs & overhead adjustment procedure for a 2004 year C 13 Acert Cat. We’re doing an inframe. We are a diesel repair shop but … read more
What are the torque specifications for a car?
The specified amount will normally be in 30° increments. Turns of 120° or 180° are preferred. Turns of 120° or 180° are easily measured by the points of the hex head of the fastener. Lubrication may be specified in order to reduce the effort that is required for the final turn.