Where is the throttle position sensor on a 2002 Honda CRV?
You will see the TP sensor right on the side of the Throttle body.
How do you reset the throttle position sensor on a Honda CRV?
Resetting the throttle body on a Honda is very simple. First, put in Your key and set the ignition to RUN for 3 seconds. Then, start the car and try to rev it up to approximately 3,000 RPM. This should force the radiator fans to come on.
Is the throttle position sensor on a Honda CRV defective?
The throttle position sensor (TPS) on the 2002, 2003, and 2004 2.4L Honda CR-V is a simple 3 wire fuel system component that can be easily tested with just a multimeter (yup, no scan tool needed!). In this tutorial I will explain the TPS test that you need to perform to make sure that it is defective (or not).
How to test the TPS on a Honda CRV?
NOTE: You can find the 1997-2001 2.0L Honda CR-V TPS test here: How To Test The TPS (1997-2001 2.0L Honda CR-V). The throttle plate angle changes as you step on or off the accelerator pedal. And of course, it’s the throttle position sensor’s job to measure it and report it to your 2.4L Honda CR-V’s fuel injection computer.
How to replace the TPS sensor on a Honda Civic?
Honda Civic: How to Replace and Calibrate TPS. 1 Step 1 – Remove the TPS. To remove the old TPS, first disconnect the throttle position sensor wiring harness. Remove the two 12mm bolts and nuts to 2 Step 2 – Install new TPS. 3 Step 3 – Calibrate the new TPS. 4 Featured Video: How to Calibrate TPS Sensor.
How to test the throttle position sensor ( TPS )?
For these two tests, go to: TEST 2: Checking Throttle Position Sensor (TPS) Power and Ground. CASE 3: The TP sensor signal’s voltage showed gaps in its voltage output as you tapped the sensor with the screwdriver.
NOTE: You can find the 1997-2001 2.0L Honda CR-V TPS test here: How To Test The TPS (1997-2001 2.0L Honda CR-V). The throttle plate angle changes as you step on or off the accelerator pedal. And of course, it’s the throttle position sensor’s job to measure it and report it to your 2.4L Honda CR-V’s fuel injection computer.
The throttle position sensor (TPS) on the 2002, 2003, and 2004 2.4L Honda CR-V is a simple 3 wire fuel system component that can be easily tested with just a multimeter (yup, no scan tool needed!). In this tutorial I will explain the TPS test that you need to perform to make sure that it is defective (or not).
For these two tests, go to: TEST 2: Checking Throttle Position Sensor (TPS) Power and Ground. CASE 3: The TP sensor signal’s voltage showed gaps in its voltage output as you tapped the sensor with the screwdriver.