When does the Caterpillar C7 engine shut down?
Lamp will start to flash at a rapid rate 70 seconds before the programmed idle time expires. The engine will down after 70 seconds after a 70 second interval. To disable the idle shut down timer, the clutch pedal or the service brake pedal must be depressed during the event 70 seconds while yellow lamp is flashing.
What is code 62 on Caterpillar C7 engine?
Code 62 Whenever the Electronic Control Module ( ECM ) detects an active fault or condition the lamp will flash at five second intervals. If the lamp turns on and if the lamp stays on after initial startup, the ECM has detected a system problem. The Diagnostic lamp is also used for the idle Shutdown timer.
What is the Flash code for a Caterpillar C7 engine?
Flash Code 55 signals that no detected faults have occurred since key switch was turned to the on position. Troubleshooting is not required for codes 35, 41, 47 and 55. Injection Actuation Pressure Control Valve fault. Code 18 Engine RPM Signal Fault.
What is the fault code for a Caterpillar engine?
Caterpillar Engine Error Codes List of Fault Identification Codes (FMI) List of identification codes of electronic units (MID) Caterpillar C15 Truck Engine B5R Fault Codes 1300 Solenoid for changing the direction of movement of the elevator 1301 The gas supply valve solenoid (GAV) in the cylinder No.1
How many miles is a caterpillar C-7 diesel engine?
The engines produced from 03′ to 06′ were known to have many issues as CAT changed manufactors that produced many engine parts. 36,000 miles isn’t alot of mileage, but CAT & Freightliner don’t always go by mileage they go by hours on the engine as well. if your warrenty was 5/100,000 than it is out of warrenty you may beout of luck.
How to find the diagnostic code for a Caterpillar C7 engine?
Here is another place to post your question. Use the diagnostic lamp to determine diagnostic flash code. Use the following to retrieve diagnostic codes if engine with a diagnostic lamp: First turn cruise control On/OFF switch to The OFF position. Second move the SET/RESUME switch to either position.
What does Flash code 55 on Caterpillar C7 mean?
Any additional diagnostic codes will follow after a pause and will be displayed in the same manner. Flash Code 55 signals that no detected faults have occurred since key switch was turned to the on position. Troubleshooting is not required for codes 35, 41, 47 and 55.