Is the Cascadia troubleshooting manual in PDF format?
This troubleshooting manual is in PDF format. Our company provides for sale original spare part catalogs, workshop manuals, diagnostic software for all models of engines, cars, trucks, buses, forklifts, tractors, harvesters, cranes, buldozers, generators, construction and agricultural machines, motorcycles.
Where are the warning lamps on a Cascadia?
The location of sensors and warning lamps on the ICU all shift to the left in this case. All other features remain the same. The trailer monitoring of SGA is not active shortly after reversing or shortly after coupling up.
How to install a new Freightliner Cascadia air conditioner?
Match wire colors along the proper side of the connector (yellow to the yellow row, green to the green row). Make sure that the two J1939 wires are installed directly across from each other, as with slots B and H in the below example. Check the contacts are locked in place.
How to connect GPS to Freightliner Cascadia harness?
On the GPS end of the harness, connect in the following order: Connect the 10-pin (A) to the GPS unit (A). Connect the 4-pin (B) to the GPS unit (B). Once the GPS unit is connected, check the LEDs on the left side of the unit. They should display the following sequence after everything is connected:
What are the fuses on a Freightliner Cascadia?
Freightliner Cascadia Fuse Box. Recently Updated.switches the power to fuse 13 on and off—thus flashing the trailer tail lamps. NOTE: R8 R8 is a single throw relay, it will only have 4 prongs. Either pin 87 or pin 87a will be missing, depending on the intended functionality of the circuit. Cascadia ® SAM PIN LAYOUT 5 2 3 7.
Where to find termination resistor on Cascadia truck?
• For termination resistor locations refer to SS 3920 J1939 Terminating Resistor Locations – Cascadia Diagnostic “Truck” CAN network Test the resistance between pins H & J at the diagnostic connector. J1939/H1939 500k baud network Test the resistance between pins C & D at the diagnostic connector.