What was the Freightliner Cascadia fault code for 2012?
Freightliner Cascadia 2012 DD15, fault code EEC 61 SPN 625 fail 14. Truck was not restarting after a normal shut down. Freightliner Cascadia 2012 DD15, fault code EEC 61 SPN 625 fail 14. Truck was not restarting after a normal shut down.
What are the fault codes on a Cascadia DD15?
Same old, same old! Both yellow check engine lights illuminated. Fault codes “fail 3 & fail 7”. Is there a list for these codes so I know what they are? Seems like this old Shaker is in the shop every week for some fault. Can’t make a cross country haul without these lights coming on!
What does cab 33 mean on Cascadia DD15?
Stopped and did what you said. It read both Cab33 & EEC61. Then read diag 2, fault 1-fail3, fault 2- fail 7. Nothing else. CAB 33 means fault is related to sab cab, EEC61 is Aftertretment. I still need SPN numbers.
What kind of injector does a Freightliner Cascadia use?
Eng 2 001 spn000655 cyl #5 injector. Eec 061 spn003719 dpf soot 15. Eec 061 sp003556 aftrtrment inj 18. Eec 061 spn003251 dpf pressure 16. … read more
How to check SPN 1231 / FMI 9 fault code?
If the resistance is greater than 5 ohms, repair the wire between pin 21 of the CPC harness connector #3 and pin 13 of the MCM 21-pin harness connector. Turn the ignition ON (key ON, engine OFF). After 30 seconds, check for an active SPN 1231/FMI 9 fault code. Code is active; replace the MCM.
How to check for an active SPN 1231?
Turn the ignition ON (key ON, engine OFF). After 30 seconds, check for an active SPN 1231/FMI 9 fault code. Code is active; replace the MCM. Refer to section “Removal of the Motor Control Module” . Code is not active; clear codes and release the vehicle. This fault indicates an interruption in ACM/MCM communication.
What causes a Cascadia engine to lose power?
This is a loss of communication or datalink from the MCM or in other words the engine control module. This can be cause by a loss of power or ground to the MCM or a possible wiring harness issue or failed MCM. Check all your fuses and relays. Test for power on both sides with the ignition switch on for your fuses.
What does EEC 61 mean on a 2012 Cascadia?
This answer was for a 2012 Cascadia w/ a Detroit DD15. EEC 61 is only part of the fault code. If you hit the square button again,write it down, then hit it again, then write that down. it should follow up with some more additional information that could help. EEC 61 is basically saying there is a problem in the After-treatment control module.
What does EEC 61 mean on a freigtliner?
EEC 61 is only part of the fault code. If you hit the square button again,write it down, then hit it again, then write that down. it should follow up with some more additional information that could help. EEC 61 is basically saying there is a problem in the After-treatment control module.
What is the code for a Freightliner truck?
The most visited question in the heavy equipment category starts with an error code on a Freightliner, code EEC 61. This is a long-distance trucker’s nightmare; hundreds of miles from the nearest service, over a thousand miles from home base, and a truck that may or may not make the drive.