What is the ICP code for a 2010 MaxxForce DT?
2010 Maxxforce DT spn 164 fmi 16 code 3333 icp above Discussion in ‘ Heavy Duty Diesel Truck Mechanics Forum ‘ started by Mack813 , Feb 22, 2019 . Feb 22, 2019 #1
What are the fault codes for MaxxForce 15?
International MaxxForce 15 (All Years) Fault Codes CODE DESCRIPTION SPN 27 FMI 0 EGRP fault: over temperature SPN 27 FMI 3 EGRP signal Out of Range HIGH SPN 27 FMI 4 EGRP signal Out of Range LOW SPN 27 FMI 7 EGRP does not agree with commanded posit
When did the International MaxxForce 15 come out?
First announced in 2009, it was put into production and placed into trucks by August 2011. However, this engine was very short lived due to its ability to not meet engine requirements that it was announced in September 2012 that it would be discontinued.
How to scan spn3464-16 engine throttle actuator command?
Code reads SPN3464-16 Engine throttle Actuator 1 control command FMI :16 Mechanic’s Assistant: What’s the make/model/year of your truck? Engine type? Mechanic’s Assistant: Are you fixing your truck yourself? What have you tried so far? No just scanned the code if its simple we fix it. if not we send to the dealer
What does FMI stand for in failure mode?
FMI” is the Failure Mode Indicator. This number represents the type of failure detected. Refer to Failure Mode Indicators (FMI) below for more information. Active” or “Previously Active” will be displayed to identify whether a fault is currently active or if the fault was previously active.
What does FMI stand for in truck diagnostics?
FMI” is the Failure Mode Indicator. This number represents the type of failure detected. Refer to Failure Mode Indicators (FMI) below for more information. Active” or “Previously Active” will be displayed to identify whether a fault is currently active or if the fault was previously active. OC” is the Occurrence Count.
What are the fault codes for International trucks?
International Trucks Fault Codes List (DTCs) for Model: 3200, 4100, 4300, 4400, 7300, 7400, 7500, 7600, 7700, 8500, 8600, BE 200, CE Bus, CXT, DuraStar, LoneStar, MXT, ProStar, RXT, TranStar, WorkStar. See also: International Trucks Service Repair Manuals PDF
What’s the ICP on a MaxxForce DT 164?
Let truck high idle until up to temp. Test drove truck for over 20 miles. When full throttle or pulling hill icp jumps from desired to 4917 instantly then code comes on then check engine and engine goes to open loop for a little bit then goes back to closed loop and normal power.As soon as you floor it under load it happens again.
What is the engine coolant sensor code in FMI?
110 2 PID 110 1212 Engine Coolant Sensor (OUT), General Temp. Plausibility Error SPN FMI PID/SID PID/SID ID FLASH CODE FAULT DESCRIPTION 132 7 PID 132 1213 Intake Air Throttle Valve Closure Detection- Positive Torque 132 14 PID 132 1213 Intake Air Throttle Valve Closure Detection -Braking Condition
Is there a charge for MaxxForce DT service?
There is no charge for this service, but standard message and data rates may apply. All the codes except for 2659, are ICP related. 2332 is ICP above spec with engine off. This is usually a bad sensor. High pressure leaks will usually cause hard or no start when hot, but the engine will run ok once it is started.