How to adjust unit injectors on engine 1?
To make an adjustment to the unit injectors on cylinders 1, 2, and 4, remove the timing bolt. Turn the flywheel by 360 degrees in the direction of engine rotation. The direction of engine rotation is counterclockwise, as the engine is viewed from the flywheel end. This will put the number 1 piston at the top center position on the exhaust stroke.
How to set injector height on C10 C11 C12 C13?
How To Set Injector Height On C10 C11 C12 C13 and some C15 Cat Engines. – YouTube How To Set Injector Height On C10 C11 C12 C13 and some C15 Cat Engines. If playback doesn’t begin shortly, try restarting your device.
How to adjust the torque of a caterpillar injector?
Turn unit injector adjusting screw (2) clockwise until the correct height is obtained. Hold the adjusting screw in this position and tighten locknut (3) to a torque of 100 ± 10 N·m (74 ± 7 lb ft). To make an adjustment to the unit injectors on cylinders 1, 2, and 4, remove the timing bolt.
How to perform a C15 overhead valve adjust?
This video goes into detail about how to do a complete C15 or 3406 Valve Adjustment Overhead . Includes the Valves, Injector Height, and Jake adjustments. IVAs and VVA adjustment are also discussed. The proper way to pin the engine and what sequence are all shown in this video. Comments and questions can be left in the comments section.
How to ensure fuel injectors are receiving the correct range?
Step 1: Turn the car on. Turn the key to the second (ON) position for this test. You want battery power flowing, but don’t want the engine running. Step 2: Set up DVOM to measure DC voltage. Use the lowest range possible if the meter doesn’t auto range.
How to set up unit injector of Caterpillar?
To make an adjustment to the unit injectors on cylinders 1, 2, and 4, remove the timing bolt. Turn the flywheel by 360 degrees in the direction of engine rotation. The direction of engine rotation is counterclockwise, as the engine is viewed from the flywheel end.
How to adjust unit injectors on Cat MXS?
Turn unit injector adjustment screw (2) clockwise until the correct height is obtained. Hold the adjustment screw in this position and tighten locknut (3) to a torque of 100 ± 10 N·m (74 ± 7 lb ft). To make an adjustment to the unit injectors on cylinders 1, 2, and 4, remove the timing bolt.