How to wire in a trailer brake controller?
How to wire in trailer brake controller video 1 51515). Then, attach butt connectors. 2 Step 5: Insert the quick plug and mount the brake controller With the wires securely crimped together, you can now plug the brake controller harness into your brake controller unit. 3 Step 6: Attach power wire to the battery
How to install a 7 way brake controller?
3. Ground the 7-way connector by screwing the white wire with a ring terminal on it into the frame of the vehicle. If you will be using your reverse trailer lights, attach the yellow wire coming out of the 7-way connector to your reverse light wire, using one of the quick splice wire connectors included with the kit.
What’s the black wire coming out of the brake controller?
The black wire coming out of the brake controller is the brake controller power supply. It will be too short to reach the battery, so you will have to use excess wire from the duplex cable to complete this connection. Route this wire to the AUX/silver post on the 20-amp (or 30-amp) circuit breaker under the hood.
Where does the duplex cable go for a brake controller?
The duplex cable runs from the trailer connector to the front of the vehicle. The black loom is a hard plastic tube that covers the 12 volt hot lead and brake wire connections at the trailer connector, protecting the connections and giving your installation a professional appearance.
Is there a problem installing a brake controller?
Even the most experienced installer will encounter it from time to time: the brake controller installation is finished, the wires have all been run, but something is going wrong.
How to install a brake controller on Chevrolet / GMC 1999?
Hardwire the open wires of the brake control adapter to the wires on the brake controller. Plug the other end of the adapter into the electrical junction box (see above). Mount the brake controller in a place that is easily accessible. A: Remove the bracket in the corner closest to the driver. B: Remove the top cover of the “Accessory Fuse Block”.
Can a 12V battery be connected to a brake controller?
12V wire was not connected to vehicle battery, 12V source used is not constant. Connect 12V wire to positive battery terminal. Brake controller detects a short on the brake wire while vehicle is idling. Corrosion in trailer and/or vehicle plug.
What does a Draw Tite brake controller do?
Draw-Tite electric trailer brake controllers are electronic devices that supply power from the tow vehicle to the trailer’s electric brakes.
How does trailer brake controller work on Chevy Silverado?
This article applies to the Chevrolet Silverado 1500 (1999-2006). A trailer brake controller displays the voltage level on the wiring traveling from your truck’s brake pedal to the trailer’s electric brakes. The higher this voltage level is, the harder your trailer brakes are being applied.