Where are the fuses on an International DT IDM?
There are fuses in there on top of the batteries for the IDM and ECM. wires all the way up to the ecm and check the wiring carefully for rubout or corrosion anywhere. 05 International DT started up and then died. There are fuses in there on top of the batteries for the IDM and ECM.
When does DT 05 international with DT will not start?
28, — ELECTRICAL CIRCUIT DIAGRAMS. 05 international with dt 05 international with dt will not start codes are , , checked fuses, relays, connections, fuses and holders at battery engine light still on will not start.
Where does the IDM connect to the dip stick?
You should check to see that there is power to the IDM at the 12 pin connector (black connector near the dip stick). It would be pin 12 and the IDM logic power would be pin 6.the toolbox – the diesel and truck mechanic forum: International intermittent power lossIDM Wiring Diagram – Diesel Forum – schematron.org
What happens if IH blows IDM fuse at Battery?
IH with dt blows idm fuse at battery on schematron.org cranks but won’t start because of blown idm fuse at battery. vin# XXXXX I need a scematic to see what is all on this circuit and the idm module location. Somewhere between the IDM relay and the fuse the wire off pin 87 will splice into 2 circuits.
Why does my dt466e quit and wont crank?
There is also a B+ fused circuit on some units and the wire is not often run in the most secure manner – meaning it can rub and blow the fuse in the battery box. The ECM is not getting power, either B+ or Ignition, not sure which and maybe neither , of course it could be an open ground circuit too, same symptoms.
What does no check engine light mean on dt466e?
Sorry forgot to say its a 2000 international 4900 with a 6 spd eaton. Thanks. Do you have a check engine light? No light = no ECM power (key on, engine off). Look at the back of the key switch and see if the wires are burnt in the connector. They may have lost connection and you have no power going out.
Where does the wire off pin 87 go?
Somewhere between the IDM relay and the fuse the wire off pin 87 will splice into 2 circuits. One is the IDM main power circuit and the other is the IDM logic power. You should check to see that there is power to the IDM at the 12 pin connector (black connector near the dip stick).
When did the Navistar IC Bus re series come out?
0000018825 International LT / RH and LoneStar Series Interactive Schematics Built 12/1/16 to 1/14/19 0000018828 International LT / RH and LoneStar Series Interactive Schematics Built 1/15/19 to 12/31/19 0000019442 IC Bus RE Series (Built September 2017 and After) Chassis Electrical Circuit Diagrams
Where is the IDM on a International 4700?
Andy : Ok so this has a built in IDM . Andy : It is integrated into the ECM in those years Andy : If it were mounted above on firewall , it would have been separate and there would have been 3 different modules there Customer: ok thats makes scence i looked under dash and not their
What kind of Fuse does a 1997 dt466e have?
Related Medium and Heavy Trucks Questions 1997 dt466e. Fuse f4 (ecm) blows when IGN turned on. Pull 1997 dt466e. Fuse f4 (ecm) blows when IGN turned on. Pull ecm connector off still.