Where is the engine harness installed in a DDEC V?
7SA821 0509Copyright © 2005 DETROIT DIESEL CORPORATION DDEC V APPLICATION AND INSTALLATION MANUAL 3.3 ENGINE HARNESS The Engine Harness (EH) is installed at the factory and is delivered connected to all engine sensors, the fuel injection system and the ECU.
What are the part numbers for a DDEC V ECU?
Part number for the DDEC V ECU is listed in Table 3-3. Description Part Number Voltage No. of Cylinders DDEC V – ECU 23530802 12/24 Volts 6 Table 3-3 ECU Part Numbers The part numbers for the ECU connectors are listed in Table 3-4.
How many volts does a DDEC II engine need?
If a DDEC II engine with an electronic starting motor requires emergency jump starting, do not exceed 16 volts DC. DDEC III and DDEC IV electronic control systems operate on 12 or 24 volts DC. If a DDEC III or DDEC IV engine with an electronic starting motor requires emergency jump starting do not exceed 32 volts DC. NOTICE:
What are the different sensor types in DDEC?
DDEC is designed to operate with several types of sensors as listed in Table “Sensor Types” . Used to monitor the crankshaft position, engine speed, turbo speed, and vehicle speed. Used to monitor manifold, and oil gallery pressures. Used to sense throttle position. Used to signal coolant level. Table 1. Sensor Types
What is the wiring diagram for a DDEC IV engine?
DDEC III/IV SINGLE ECM TROUBLESHOOTING GUIDE. Figure Series 50 Engine DDEC IV EGR Injector Harness Schematic. (Sheet 1 of 4). (Rev. This particular image (Detroit Diesel Series 60 Ecm Wiring Diagram Luxury Ddec Iv Wiring Diagram Series 60) earlier mentioned can be classed with:submitted.
What are the pin numbers on the DDEC III connector?
Oct 27, · These are the pin numbers on the DDEC III and DDEC IV vehicle connector on your ECM. The vehicle harness plugs into this connector. This diagrams what you would see if you looked directly at the connector.
Which is engine control module does DDEC 3 use?
Pinouts, Diagrams, and More for the DDEC 3 and 4. DDEC 3 and DDEC 4 engine computers (Engine Control Modules, ECMs) are used with Detroit Diesel Series 50, 60 and 6V92 engines.