How to fix a cat 226 skid steer problem?
Replaced fuel cut off solenoid which fixed the shut off problem. Ran jumper wire from green wire to power relay A to green wire on power relay B and now all the lights come on and all my fuses have power. So now, machine starts and lights on console operate properly. Now…the pilot controls fail to operate when I push the park light switch.
Where are the relays on a cat 226?
So far I have found that the B Relay in the engine compartment has power going to the relay (red wire) but the activation wire (green) is not, with the key on. On the left top inside engine compartment there are 4 relays. They control all that stuff third one from the rear is engine fuel circuit or shut off.
What’s the problem with the cat 3126 engine?
Heres the problem….
What happens when you hit the brakes on a 2001 cat 3126B?
My 2001 3126B shuts down when I hit the brakes hard. It has done this at 35 MPH and at a coast in the shop. Feels like an electrical/electronic shutdown as it is instantaneous. Does not loose power it just shuts down. Starts right back up and runs fine but don’t give it a hard brake because it will shutdown.
What does diagnostic mean on Cat 262C skid steer?
The diagnostic will generate a level 2 warning. The machine will be brought to a stop. The park brake will be engaged and will remain engaged until the diagnostic has been cleared and the hystat lever has been returned to the neutral position. Test Step 1. CHECK THE SENSOR POWER SUPPLY
Where is the jumper wire on a cat 262C skid steer?
Disconnect the negative battery cable and turn the key start switch to the OFF position. Disconnect the machine harness connector at the right joystick. At the harness connector for the joystick, place a jumper wire between the contact for the sensor return (wire 203-BK) and the signal contact (wire L804-WH) .
How to fix a skid steer electrical problem?
On top of injector pump is fuel cut off just unplug it machine will shut off Replaced fuel cut off solenoid which fixed the shut off problem. Ran jumper wire from green wire to power relay A to green wire on power relay B and now all the lights come on and all my fuses have power.