What is the DT466 code on an international 4300?
International 4300 2007 dt466 code pdi164 fmi13 have recently replaced idm and had flashed to ecm. It was running rough with that code … read more I have an 07 International 4300 with dt466 that has a no start condition. Had trouble with the IDM relay overheating, and eventually the truck … read more Auto Mechanics 1&2/diesel…
Why is the ECM not working on my DT466 MHH?
If not then ECM not powering up. I have saw a few times with the fuse box located out on the driver side above the steer tire give fits. The fuse holder will get loose and not make good connection. In that fuse box on the fender. Check the IDM relay. There should be battery power on 2 of the terminals. Those are the clean power wires.
What is the DT466 code for no IDM?
working on a 2005 international… working on a 2005 international with a dt466 had a code for #1 and#5 injector replaced them both now I have a code for no idm and ecm commiunication position signals. The CKPO and CMPO channels are in phase with the CKP and CMP signals received by the ECM.The ECM and IDM are in continuous communication.
What is the code for no IDM and ECM commiunication position signals?
working on a 2005 international with a dt466 had a code for #1 and#5 injector replaced them both now I have a code for no idm and ecm commiunication position signals. The CKPO and CMPO channels are in phase with the CKP and CMP signals received by the ECM.The ECM and IDM are in continuous communication. The CKPO and CMPO signals
What to do with a 2005 International 4300?
Hi i have a 2005 international 4300 with a dt466 and has an no start situation. We have replaced the injector harness,valve cover gasket, icp sensor,idm with reprogramed ecm, icp pigtale (the one that goes from the external harness to the valve cover) and batteries.
What’s the fuel pressure on a 2005 International 4300?
After the rebuild it started up grea … read more 05 International 4300 DT466 5H121916- 300k plus mileage Crank no start. After we had to remove timing cover both parts due to cracks in air compressor mount area. Checked fuel pressure 35psi.
Can a 2005 International shut off while driving?
I have a 2005 International with a DT466. The issue I’m having is without warning, while driving down the road the truck will lose power and then shut off. No engine light comes on, no codes in the Dash changed the fuel filter checked the fuses in the battery box, Checked the relays underneath the hood and replaced the camshaft sensor.
Is the IH 4300 DT466 getting hard to start?
I have an 05 IH 4300 DT466 with 131K miles on it. I have had a small problem with it before, usually first thing in the AM. But now it doesn’t want to start no matter what time of the day it is. If its been sitting for any length of time it cranks and will finally start after about 45 seconds.
What kind of engine does a 2005 International 4300 have?
I have a 2005 International 4300 with a DT466. The engine was just rebuilt. The “O” Rings on the sleeves had gone bad causing the coolant to go into the crankcase. After the rebuild it started up grea … read more 05 International 4300 DT466 5H121916- 300k plus mileage Crank no start.
Why is my DT 466 getting hard to start?
The 466 uses oil to hydraulicly actuate your injectors. Once the o-rings start to leak, the high pressure pump has a hard time building pressure to actuate the injectors. Sometimes it takes 30 seconds to finally build enough pressure to start. This is about a 2 hour job at a dealer. Did you check ALL fluids accurately?
Where are the fuses on an International DT IDM?
There are fuses in there on top of the batteries for the IDM and ECM. wires all the way up to the ecm and check the wiring carefully for rubout or corrosion anywhere. 05 International DT started up and then died. There are fuses in there on top of the batteries for the IDM and ECM.