Where is FMI 15 located on a MaxxForce 13?
FIM 14 SPN 3055. FMI 15 BOTH ARE ACTIVE When it is loaded loses all the power This is what it looks like and it is located behind your cluster in the dash . It will be tied up against the wiring near the left windshield pillar . This module does not affect performance in any way . It is a module that stores freeze frame data from fault codes.
What happens if SPN 132 FMI 11 MAF sensor fails?
If SPN 132 FMI 11 – MAF sensor calibration failed – Insufficient number of data points sets, engine conditions are not stable to accept MAF calibration 1. Check to ensure entry conditions were all met (if EOT or ECT become lower than 176 F, test will fail) 2.
Is the MaxxForce 13 an international pro star?
I have an international pro star 2014 with the maxxforce 13 has lost power, has an active code SPN 524285. IMF 14 Have truck repair questions? Ask an Expert By continuing to use this site you consent to the use of cookies on your device as described in our cookie policy unless you have disabled them.
What is SPN FMI for mass air flow sensor?
DIAGNOSTIC TROUBLE CODES SPN FMI DESCRIPTION 132 11 MAF sensor calibration failed – Insufficient number of data points 132 13 Mass Air Flow sensor out of calibration 132 14 MAF sensor calibration failed TROUBLESHOOTING Instructions on how to record a ServiceMaxx recording for a casefile: 1.
What does a NAV-1 operating system fault cycle mean?
NAV-1 Operating system fault Cycle power to clear the condition. Upgrade to the latest firmware. Continuous occurrence indicates a hardware error. If the problem persists, contact your dealer. NAV-2 Operating system fault Cycle power to clear the condition. Upgrade to the latest firmware. Continuous occurrence indicates a hardware error.
Is the est DTC list free of SPN 157 FMI?
Check for associated faults. Using Electronic Service Tool (EST) with ServiceMaxx™ software, check Diagnostic Trouble Code (DTC) list for SPN 157 FMI 3, 4, 20, and 21 (FRP) or SPN 633 FMI 3, 4, and 5 (FPCV). Is the EST DTC list free of SPN 157 FMI 3, 4, 20, and 21, and SPN 633 FMI 3, 4, and 5?
What is the diagnostic code for FMI failure?
FMI FailureModeIdentifier: Identificationoffaulttypes. 2 Group28 EngineControlModule(ECM)DiagnosticTrouble Codes(DTCs) SAEJ1939FMITable