Do all diesel engines use an injection pump unit?
Simple fuel systems use gravity or air pressure to get fuel from the tank to the injection pump. On modern high-speed diesel engines, a fuel transfer pump is normally used. Modern injection pumps are almost all jerk pumps that use the plunger and cam method of fuel injection.
How do you time a 3208 Cat engine?
3. To check the timing, remove the timing pin and the bolt. Turn the crankshaft (clockwise) two revolutions and install the timing pin and bolt back in place. If the timing pin or bolt cannot be installed, the fuel injection pump camshaft must be put into time again before step 4 is done.
How much does it cost to install an injector pump?
To get your injector pump replaced, you are looking at anywhere from $1,400 to $1,875. For labor, you should pay between $770 and $1,000, while parts will run between $685 and $900.
What are the two types of injection pump?
There are two types of fuel injection pump; the barrel cylinder type and the monoblock cylinder type.
Is injection pump Same as fuel pump?
An Injection Pump is the device that pumps fuel into the cylinders of a diesel engine. It is also common for the pump belt on gasoline engines to be driven directly from the camshaft.
Is a fuel pump and injector pump the same?
The fuel pump is one of the most vital components for making the car run. It uses pressure to literally pump fuel from the fuel tank to the injectors, so it’s not that uncommon for it to be also called an injector pump. There are two types of fuel pumps: mechanical (older) and electronic (newer).
How you should install injection pump?
1) Rotate the engine until the #1 piston rises to its highest point. 2) Connect the new pump to all fuel lines, except for the top hard lines that connect to each injector. Do not connect pump yet. 3) Press the primer pump to build pressure, open bleeder valve to release air, then close bleeder valve.
How to remove fuel injection pump from Caterpillar 3208?
Remove plug from cover in fuel injection pump housing and install tool (A). Turn the crankshaft (clockwise) until the timing pin drops into the grove (slot) in the fuel injection pump camshaft. 2. Remove two nuts (2) and the tachometer drive housing (1) 3. Remove tachometer drive shaft (3) 4.
Is there a warranty on a Cat 3208 fuel pump?
1 Year Unlimited Mile Warranty. *FREE Ground Shipping. Remanufactured injection pump for Cat 3208 turbocharged engines, with under 300 horsepower. This pump is tuned to your application’s horsepower rating before shipping to you. Please provide your engine serial when ordering.
What kind of fuel pump does a cat use?
Not finding what you’re looking for? 9L6542 Caterpillar Camshaft, for CAT Diesel Fuel Injection Pump 3208. CAT CAM
Where is timing pin on caterpillar fuel injection pump?
Put bolt (3) through the front cover and into the hole with threads in the timing gear. The bolt from hole (5) can be used. 4. If the timing pin is in the notch in the camshaft for the fuel injection pumps, and bolt (3) goes into the hole in the timing gear through timing hole (4), the timing of the fuel injection pump is correct.