What is the fault code for a crown forklift?
CROWN Forklift Truck Fault Codes list CROWN Diagnostic Fault Codes (Flash Codes) DFC – PROBABLE FAULT – FAULT ACTION * – CORRECTIVE ACTION FIRST CHECK 12 NONE. Signifies the end of one pass through the fault list. NONE. None, used as end of the fault listidentification 141 (14) ECTRangeLow. Coolant Sensor failure or shorted to GND TurnOnMil.
Can a crown forklift be used on dock?
On the dock or in an aisle, Crown’s electric counterbalance forklifts can meet rugged real-world challenges with power, productivity and performance while providing the efficiency and safety of electric operation.
Who is the Tech on the Crown forklift?
Crown offers a variety of service and parts programs to ensure you receive maximum value for your investment and the lowest total cost of ownership. “Brian is the tech assigned to our facility. He’s taking care of our equipment like it’s his own – truly a partner.“
What makes crown forklift parts last so long?
Crown Integrity Parts are designed, manufactured and tested to ensure their performance and long-term value. Made with only the highest quality materials, our forklift parts often last two to three times longer than look-alike parts, helping to maximize your total cost of ownership.
What are the safety precautions for JLG lift?
INTRODUCTION – MAINTENANCE SAFETY PRECAUTIONS 3121136 – JLG Lift –a MAINTENANCE SAFETY PRECAUTIONS A. GENERAL This section contains the general safety precautions which must be observed during maintenance of the aerial platform.
How to clear forklift error code Yale 2005?
How to clear forklift error code: Hyster and Yale 2005 and newer models ERROR CODE DESCRIPTION 100-2 Engine Oil Pressure OORH at Stall 100-2 Cummins-Code 435 100-3 Engine Oil Pressure OORH 100-4 Engine Oil Pressure OORL
How to check the coolant in a forklift?
Check coolant system for radiator blockage, proper coolant level and for leaks in the system. Possible ECT short to GND, check ECT signal wiring. SECM (Signal) Pin B15 to ECT Pin 3 SECM (Sensor GND) Pin B1 to ECT_IR_Fault. Engine coolant temperature not changing as expected Check the throttle connector and pins for corrosion.