Is there a torque derate condition on a 2013 Cummins?
I have had a 2013 Pete with an ISX15 CM2350 550HP in the shop several times over the past month that is driving me nuts. It sets fault code 3714 – Engine Protection Torque Derate – Condition Exists. The driver display says 25% torque derate in 3 hours. It starts to count down, but never goes 3 hours until it clears itself.
What’s the fault code for a Cummins derate?
It sets fault code 3714 – Engine Protection Torque Derate – Condition Exists. The driver display says 25% torque derate in 3 hours. It starts to count down, but never goes 3 hours until it clears itself.
Can a diesel engine derate be suspended during an emergency?
Vehicle speed and engine power (torque) derates can be suspended during emergency operation. Examples include excessive exhaust back pressure from an overloaded diesel particulate filter (DPF) and running out of Diesel Exhaust Fluid (DEF).
How long does it take a Cummins engine to derate?
It sets fault code 3714 – Engine Protection Torque Derate – Condition Exists. The driver display says 25% torque derate in 3 hours. It starts to count down, but never goes 3 hours until it clears itself. It has not actually derated.
Why is my Ford truck in derate mode?
The shop diagnosed the truck with a bad particulate sensor. The sensor was replaced and the code did not come back. The 3712 and 3714 codes however would not clear, and the engine was in derate mode. Below you can see the conditions for clearing the code:
Is there a 5 mph Def derate for Cummins?
Information – Aftertreatment SCR Operator Inducement – Data Valid But Above Normal Operating Range – Most Severe Level. Critical SCR related fault codes have been active for an extended period of time and require immediate attention. Immediate engine power derate. Vehicle speed will be limited to 5 miles per hour or 8 km per hour.