Is there an electrical fault on my international MaxxForce 7?
We replaced the long block on a 2011 international Maxxforce 7. We finally got it all back together and went to try and fire it up and basically got nothing but an electrical fault on the dashboard and the truck doesn’t do anything. I can hear the relays clicking but getting nothing. 1HTJTSKL5BH359690. That is a cluster fault .
Do you have cookies on international MaxxForce 7?
By continuing to use this site you consent to the use of cookies on your device as described in our cookie policy unless you have disabled them. Electrical fault on a 2011 international maxxforce 7. 2011…
Why is my MaxxForce 7 not starting up?
Ok so after looking over the fuses I saw a blown fuse to the tcu that’s inline with the power from the batteries. Now we have power to the tcu and now the starter cranks but she won’t fire up. Scanner is telling us that the fuel injectors are below normal operational range. So we are trying to bleed the system but still not starting up
What happens when there is an electrical fault?
An electrical fault is a condition which can cause equipment failures (in transformers, transmission lines, alternators, busbars, etc.) and disturbs the normal working of the system. The faults can also lead to the death of humans, birds and animals along with equipment failure and electric power supply interruption. 1. Open Circuit faults 2.
What are the effects of an open circuit fault?
(i) The effect of open circuit faults can lead to the reduction of actual loading of the alternator. This will cause acceleration of alternator and hence it runs slightly greater than synchronous speed. This over speed can cause over frequency. 2. Effects of short-circuit faults
Why is my MaxxForce 11 ECM not working?
ECM doesn’t power up and you won’t be able to communicate to it. You need to check ignition and battery power sources to the ECM and ground connections. With the key on, try wiggling the clean power interconnect cable in the battery box that has a couple of fuses on it. Then follow that harness to connection plugs and check them also.
What are the codes for the MaxxForce 11?
It has codes SPN 639 FMI 14, SPN 2000 FMI 9 and 19. Also 524285 14. I took this readings from the screen on the truck, because I can connect the scanner, but there is no data coming from the ecm. I checked the powers and grounds to the ecm OK. I checked the ohms at the terminals C and D of the diagnostic plug 57.5 ohms.
What makes an international MaxxForce DT No start?
Sounds different when cranking as well. Will not even start on starting fluid, not even a little bit. It does not build oil pressure while cranking. Codes are engine exhaust valve actuation system oil pressure, brake switch, and engine turbocharger 1 outlet pressure. SPN 4287, SPN 5541 and SPN 597.