How do I check my Eaton Ultrashift code?
To Retrieve Inactive Codes: Start with the key in the ON position. Turn the key OFF and ON four times within five seconds ending with the key in the ON position. After five seconds, the gear display begins flashing two-digit fault codes. If no codes are active, the gear display will flash code 25 (no codes).
How do I calibrate my Eaton XY shifter?
To calibrate the neutral position of the shifter along the Y–Y axis, the shift finger is moved from the old or presently stored neutral position, forward and rearward along the Y–Y axis at each rail position into touching contact with the inner wall surfaces of each of the shift blocks.
How does Eaton UltraShift work?
Built upon the Fuller 13- and 18-speed manual transmissions, the UltraShift PLUS Performance Series uses an electronic clutch actuator to provide faster shifting and smoother engagement. At idle, it fully engages the clutch giving the driver ultimate control in challenging situations.
What is a XY shifter?
Briefly, X-Y shifters are devices which control the X—X (or selection directional) and the Y—Y (or engage/not-engaged directional) position of a shift member, such as a shift finger or the like. Typically, two separate fluid or electric motors are used to control the X—X and Y—Y positions.
What is smart shift transmission?
Smart-Shift® sets the industry standard for “Electronic Shift” applications, and can be installed into any vehicle equipped with an automatic transmission. No more missed gears or waiting in traffic for other actuator systems to slowly move. Smart-Shift® travels from Park to Drive in 1.3 seconds!
What’s the No Code on an Eaton transmission?
If no faults are active, the service light will flash code 25 (no codes). Two digit fault codes will be displayed in the gear display. Some vehicle may be equipped with a service light.
How to get a fault code on a Freightliner?
Turn the ignition key ON but do not start the engine. If the engine is already running, you may still retrieve codes, however, do not engage the starter if engine stalls. 4. To Retrieve Active Codes: Start with the key in the ON position. Turn the key OFF and ON two times within five seconds ending with the key in the ON position.
How do you retrieve a Eaton Fuller fault code?
After 5 seconds, the Service light begins flashing two-digit fault codes. If no faults are active, the service light will flash code 25 (no codes). To Retrieve Inactive Codes: Turn key on. Turn the key off and on 4 times within five seconds ending with the key in the on position.
How to troubleshoot an Eaton ultrashift plus fault code?
When troubleshooting an Inactive fault code, use the Fault Isolation Procedures to guide you to the wiring and connectors associated wi th that fault. Once PD Mode is activated, flex the wiring harness and connectors to attempt to recreate the fault.