What transmission is in a 1983 Ford Ranger?
A four-speed manual transmission was standard on all engines for 1983 and 1984, with a five-speed manual as an option; a three-speed automatic was offered on 2.3L and 2.8L engines.
How do I identify a C3 transmission?
The transmission’s oil pan attaches to the bottom of the transmission with several retaining bolts, which are located around the entire lip of the pan. Count the total number of oil pan retaining bolts. If the pan uses 13 bolts, the transmission is a C3. If the pan uses 11 bolts, the transmission is a C4 or a C5.
How can I tell if I have a transmission AODE?
Look for the electronic cable and electrical plug. AODE and 4R70W transmissions have a plug on the driver’s-side rear of the transmission housing. This is where the electronic control cable plugs into the unit and is what differentiates the older AOD transmission from AODE and 4R70W units.
What kind of automatic transmission does a Ford Ranger have?
A4LD – The C3 was modified into the A4LD 4-speed automatic by adding an overdrive gear, which the C3 lacked. This was the first Ford automatic to use an EEC-controlled torque converter lock-up clutch. Electronic shift control for the 3–4 shift was later added, another first, though other gears remained hydraulic.
When did the Ford C3 transmission come out?
Used C3 Transmission for Sale. The U.S. production of the C3 gearbox in the Ford family lasted from 1974 to 1989. This automatic edition is one of the best three-speed units produced for a variety of vehicles.
When was the A4LD replaced in a Ford Ranger?
It was replaced by the 4R44E and 4R55E in 1995. The A4LD is a weak transmission, and is known to fail in offroading (4×4) applications.
Can you sell a C3 transmission for money?
Before spending money on a used C3 transmission for sale, it is helpful to know more about the history of this unit. Paying retail price or higher for a used Ford transmission is the mistake some buyers make. A C3 transmission swap is the industry term for changing out a defective unit or upgrading to a compatible design.