How do you switch to 4×4 high?
Because these roads provide their own traction, using 4WD can lead to drivetrain binding and can ruin your vehicle. No matter what vehicle you drive, never shift to 4WD when traveling at high speeds or when on dry, level roads.
How do I get my Ford Ranger out of 4WD low?
If that doesn’t work, try starting the truck put the transmission gear selector in neuteral. Then put the 4×4 switch/button into 4 low for a few seconds. Now put the 4×4 switch into 4 hi and then 2wd.
Why does my 4×4 not engage?
The flashing light on the dash indicates the 4WD system has not engaged properly and that you have a technical fault somewhere. This could be in the form of any of the following: An electrical fault such as a corroded wire or faulty 4WD dial/switch, A component failure such as a faulty transfer case module or actuator.
Why does my Ford Ranger 4×4 not turn on?
It is an automatic with an electronic switch. When I turn on the ignition both the 4×4 and 4L lights turn on with the other lights. But when I turn the knob from 2H to 4H the lights do not turn on. It is an ex-council car which was not used for any 4wding and I’m assuming this lack of use could be the cause of the problems.
Where are the shift buttons on a Ford Ranger?
1989 saw a new dash design in the Ford Ranger, and the new design allowed for a place to mount the 4WD shift buttons. This meant they were now mounted in the dash, instead of in an overhead console. The manually shifted transfer case was still available during these years.
Can a Ford Ranger shift to 4WD Low range?
Note: The shift control module receives speed input from a speed sensor on the vehicle. It does not allow the transfer case to shift into 4WD if it is moving to fast, or in to 4WD Low Range if it isn’t stopped. Additionally, the transfer case will not go in to 4WD Low Range (4LO) unless it is in 4WD first.
How does the front axle work on a Ford Ranger?
The front axle uses a locking hub (1983-2000) to lock (connect) the front wheels to the axleshafts. If these hubs are not locked, the wheel will not receive power from the axle. Note: the 2001-2011 4WD Ford Ranger has a live front axle.