How do I reset my UConnect 2013 Ram?
Five Easy Steps to Reset UConnect®
- Ensure your vehicle is in park and in “Run” mode.
- Press and hold down the volume and tuner knob buttons at the same time.
- Hold down the knobs for 10 – 20 seconds.
- After holding down the knobs, the screen should flash your vehicle brand name and then go dark.
How do you soft reset Uconnect?
For the latest Uconnect® version 8.4, this is how you can perform a soft reset of the system:
- Turn your key in the ignition to “Run,” but leave the car in park.
- Simultaneously press the volume button and the tuner knob at the same time.
- Continue pressing them down for 10 – 20 seconds.
What to do if Uconnect is not working?
There are a few reasons why the Uconnect system will not connect properly with your mobile phone.
- Use a compatible phone with Uconnect.
- Verify the Bluetooth version on your phone.
- Enable Bluetooth on your phone.
- Turn on the car stereo and enter the Bluetooth pairing code.
- Pair the mobile phone with Uconnect.
Why is my Dodge Ram stuck in 4th gear?
Today my 2009 Dodge Ram got stuck in fourth gear. It will go in neutral and reverse but not in drive. It is stuck in 4th gear in the auto stick mode. It happened while at a stop light. Check engine light came on. The computer scan says a code of PO750 LR Solenoid Circuit.
What does it mean when transmission is stuck in 4th gear?
Transmission stuck in 4th gear. Today my 2009 Dodge Ram got stuck in fourth gear. It will go in neutral and reverse but not in drive. It is stuck in 4th gear in the auto stick mode. It happened while at a stop light. Check engine light came on. The computer scan says a code of PO750 LR Solenoid Circuit.
What’s the problem with my Dodge Ram 1500?
The computer scan says a code of PO750 LR Solenoid Circuit. Samething happen to my 2010 Ram and i took it into the dealer. It sat there from Saturday until Tuesday and I was told that it was a problem with the computer system.