How do you check the transmission fluid on a 2003 Lincoln Aviator?

To check your automatic transmission fluid, follow these steps:

Pull out the dipstick. With the gearshift in Neutral or Park and the parking brake on, let your engine run.
Check the fluid.
Wipe the dipstick with a clean, lint-free rag; then reinsert it and pull it out again.

How do you put transmission fluid in a 2003 Aviator?

Place the range selector lever in the PARK position. With the engine running, position the vehicle on a hoist and set it as close to level as possible….

Apply a maximum of 206.85 kPa (30 psi) to the open end of the vacuum/pressure hose from the special tool.
Add one pint of transmission fluid into the fluid pan.

Where is the transmission dipstick located on a 2004 Lincoln Aviator?

Anonymous. There is no “Dip Stick” on this Transmission. Instead, there is a Drain/Fill/Check Hole on the bottom back side corner of the Transmission.

How do you put transmission fluid in a Lincoln Aviator?

remove the plug slowly, i believe it is an 11mm bolt, if fluid drips out, the level is ok, if no fluid comes out, there is a small plastic screw on cap on top of the transmission itself on the driverside near the oil filter cap, add fluid slowly untill fluid starts to drip out of the plug hole, once the fluid starts to …

What transmission does a 2003 Lincoln Aviator have?

Used Transmission

Year	2003
Transmission Tag	3L2P-FE, 3L2P-FB
Transmission Code	5R55S
Transmission Speed	5
Transmission Drive Type	AWD

What kind of oil does a 2003 Lincoln Aviator take?

Engine Oil

Viscosity:	5W-20 (All TEMPS)
Capacity:	6 quarts (with filter)After refill check oil level.
Torque:	10 ft/lbs (Oil Drain Plug)

How much transmission fluid does a 2003 Lincoln Navigator take?

For Automatic Transmission: 4R100….MA5

Notes:	This specification has been updated from Mercon to Mercon V per TSB 06-14-4
Capacity:	4 speed 26 Plate 4R100 Total Fill 17.6 quarts 4 speed 20 Plate 4R100 Total Fill 17 quarts 6.4 quarts Initial Fill

Navigation