How do you reset the computer on a Chrysler Town and Country?
How to Reset the Computer on a Chrysler Town & Country
- Locate the OBD port, which is the same size and shape as the scan tool’s connective end; the port can be found on the underside of the driver’s-side dash next to the steering column.
- Plug the scan tool into the port.
- Wait for the scan tool to retrieve the codes.
How do you reset the computer on a Dodge Caravan?
Disconnect the battery for 1 minute and re-connect. start the vehicle and hold the revs at 1800-2000rpm for 10 seconds let the revs lower on their own then turn the a/c on and repeat. this will reset the base idle of the engine.
How do you reset the check engine light on a 2009 Chrysler Town and Country?
You can employ a couple of methods to reset the warning light.
- Park the vehicle on a level surface and shut the engine off.
- Sit in the driver’s seat, turn the ignition key to the “Accessory” position for about ten seconds and then turn it off.
- Crank the engine on the fourth turn of the ignition key.
When did the 2010 Chrysler Town and Country engine shut off?
For the 3rd time, on 1/31/17, our 2010 Town & Country 4.0 liter engine shut off while driving/coming to a stop. My wife was leaving her job this happened all three times within 1 mile of her employer. She was in town driving about 20 mph when it stopped. The traction control light came on then lost power.
Why did my Chrysler Town and Country stall?
On May 2, 2018 it stalled 3 times in 1-2 miles. The dealership said it was because the Throttle Body was dirty. They cleaned it and $180 later it still isn’t fixed. It stalled the next day.
Why does my Town and Country not start?
If your Town and Country isn’t getting enough fuel, or any fuel at all, it may have a bad fuel filter, bad fuel pump, or bad fuel injectors. Without the proper amount of fuel getting into the combustion chamber, the Town and Country will crank, but not start. 2. Ignition Issues
What’s the firing order on a Chrysler Town and Country?
The engine does not haveprovisions for a free wheeling valve train. The cylinders are numbered from front to rear, with the right bank odd numbered, and the left bank even numbered. The firing order is 1-2-3-4-5-6.