Does the 2008 Ford Focus have transmission problems?

Does the 2008 Ford Focus have transmission problems?

The transmission issues with the 2008 Ford Focus were a little more serious than the previous year. Some drivers reported a total transmission failure that occurred on average pause. The cost for repairing this problem was about $2,700.

Why can’t I jump start my Ford Focus?

The most common causes that hinders normal starting operation of your Focus are dead key fob battery, dead 12v battery, corrosion on battery terminals, bad alternator, clogged fuel filter, broken starter, blown fuse, empty gas tank, immobilizer error or any fault in the electrical system.

How do I manually start my Ford Focus?

Insert the Intelligent Access key with the buttons facing to the back and the key ring up. Then use the Start / Stop ignition button and brake pedal to start your vehicle as usual. Once the vehicle is started, the key can be removed from the backup slot, if you wish.

Is there a problem with my Ford Focus SE?

I have a 2008 Focus SE Sedan that was purchased early January 2008. I am experiencing intermittent “transmission” problems. Problem has occurred at least a dozen times since January.

What are the problems with a 2008 Ford Focus?

1 Rear End Noise And Abnormal Wear On Tires 2008 Focus Average Cost to Fix: $1,000 Average Mileage: 40,000 mi 2 Transmission Failure 2008 Focus Average Cost to Fix: $2,600 Average Mileage: 86,000 mi 3 Ignition Switch Failure 2008 Focus

What is the diagnostic code for a 2008 Ford Focus?

The next time this happens, talk to your service manager about TSB 08-5-8. Some 2008 Focus vehicles equipped with 4F27E automatic transaxle and built on or before 1/29/2008 may experience no 3rd or 4th gear. Possible diagnostic troubles codes (DTCs) P0733 and/or P0734.

Why is there no 3rd gear on my Ford Focus?

Some 2008 Focus vehicles equipped with 4F27E automatic transaxle and built on or before 1/29/2008 may experience no 3rd or 4th gear. Possible diagnostic troubles codes (DTCs) P0733 and/or P0734. The cause may be a direct clutch snap ring out of position caused by the reverse clutch wave spring.

Posted In Q&A