How do you reset a 2008 Dodge Caravan?

How do you reset a 2008 Dodge Caravan?

How to Reset Oil Life: Dodge Grand Caravan 2008-2016

  1. 1-Turn the ignition to run (second position)
  2. 2-Press slowly the accelerator pedal all the way down three times within 10 sec.
  3. 3-Turn ignition OFF.
  4. 4-Then turn the ignition to RUN or start the engine to verify if the oil life has been reset.

Where is the IOD fuse on a 2008 Dodge Caravan?

Before storing a vehicle, remove the IOD fuse to reduce discharge….Where Is the IOD Fuse Located?

Vehicle TIPM / IOD Fuse Location
Dodge Grand Caravan (2005) left side of the fuse box under the hood, near the battery
Dodge Grand Caravan (2008) engine compartment near the battery. (view the fuse diagram for model years 2008 to 2010 by clicking here)

What causes P1745?

It sounds like you downloaded Code P1745 which refers to line pressure being out of range (high) for too long. The line pressure solenoid could be faulty and/or the solenoid harness is open, shorted, or has high resistance (poor electrical connections). That possibility should be investigated and ruled in or out first.

How do you reset the check engine light on a Dodge Grand Caravan?

Start by Disconnecting Your Battery

  1. Turn off your ignition.
  2. Put on a pair of safety gloves and glasses.
  3. Find your battery’s negative terminal.
  4. Loosen the nut on the negative terminal with a wrench.
  5. Pull the negative connector from the battery and set it aside for 30-60 seconds.

How do I reset my Dodge Caravan radio?

To get into it, You need to press and hold the up and down buttons for five seconds. You’ll get a menu You typically don’t see: Here You can choose “reset to factory defaults”. Select that option, and You’ll be prompted to wait for 30 seconds, and then it’ll reset.

What does it mean when it says no fuse?

This indicates a mechanical or electrical condition that is not scanned or stored. Since this is the case, IMHO, it seems to only leave the clockspring. While the horn may blow, it doesn’t mean the airbag test circuit is seeing full continuity, hence the light.

Posted In Q&A