What is Maestro RR?
Advanced Programmable Radio Replacement Module. Web-programmable radio replacement interface for integration with factory systems including steering wheel controls, media player, hands-free telephone, voice commands, and satellite radio modules.
How do you connect a rear view camera to a computer?
Attach your monitor’s power cable to a fuse tap. Connect your remaining bare wire cable to the backup monitor’s power cord. Then, push the positive (usually red) end of the bare wire cable into the open end of a fuse tap. Finally, crimp the 2 cables together with a pair of pliers.
What kind of wire to use for rear view camera?
For safety, make sure you wrap the combined wires in electrical tape. Make sure you poke your positive (usually red) bare wire through the positive reverse light wire and the negative (usually black) bare wire through the negative reverse light wire. Route your camera’s video cable to the front of the car.
How to hook up back up camera to car radio?
How to hook up belsee back up camera to radio? Trigger-A on the Reversing Wire and Trigger-B on the Rear lamp + and the reversing camera goes. We were unable to load Disqus Recommendations. If you are a moderator please see our troubleshooting guide. How to update Firmware Software …
How to install an aftermarket rear / reverse camera?
Normally those after market rear camera are with some installation instruction card inside the box. If not, do not worry, please check at the following photos. We firstly need to figure out what function of those wires from the rear camera, and where do they goes to connect.
How do you hook up a camera to a radio?
Most cameras will come with an installation kit, so use it and install the camera properly. This is where it gets a little complicated for many people, so pay attention. a). Connect the DC power cable to the red DC female plug of the camera. The DC power cable has 2 wires. One wire is usually red, and the other, black. b).
Attach your monitor’s power cable to a fuse tap. Connect your remaining bare wire cable to the backup monitor’s power cord. Then, push the positive (usually red) end of the bare wire cable into the open end of a fuse tap. Finally, crimp the 2 cables together with a pair of pliers.
How do you hook up a camera to a car reverse light?
Connect the DC power cable to the red DC female plug of the camera. The DC power cable has 2 wires. One wire is usually red, and the other, black. b). Connect the other 2 ends of this power cable to your vehicle’s reverse light.
For safety, make sure you wrap the combined wires in electrical tape. Make sure you poke your positive (usually red) bare wire through the positive reverse light wire and the negative (usually black) bare wire through the negative reverse light wire. Route your camera’s video cable to the front of the car.