Should I drive in 2WD or auto?
Basically, 2WD for everyday driving, Auto when the road surface conditions vary, 4HI for snow or ice covered roads and some off road, and 4LO for off road only.
When should I use 4HI?
When to Use 4HI:
- When you’re on slippery surfaces and driving at street or highway speeds.
- When you’re stuck in snow, mud or ice.
What does 4Lo mean in Land Cruiser?
This means the transfer case is in 4 wheel drive low. If the car is driving normal and this light is on it means the position switch has come part internally and needs to be replaced, Here is a diagram that shows the switches location. ( below)
Is it bad to turn sharp in 4WD?
as said on slippery surfaces it is ok in 4 wheel, but it souldnt romp. on dry pavement or even wet pavement while parking, put it in 2 wheel to make your truck happy and avoid any possible breakage.
What causes the transmission indicator light to come on?
Malfunctioning sensors will also give false readings causing the light to come on so always have the sensors tested again. One of the most common issues that causes this indicator light to illuminate is that the transmission fluid temperature is higher than normal.
What does the blinking 4 wheel drive indicator mean?
So what is that 4 wheel drive indicator blinking on your dashboard means? The purpose of the 4 wheel drive light is to indicate when you have engaged 4WD mode by selecting 4H. When the light flashes continuously for more than 30 seconds it signifies there is a problem somewhere on your drivetrain system and that 4WD has not engaged properly.
What to do when your transmission light comes on?
Here’s a few practical things you can do to try and self-diagnose the issue. As stated, stop immediately. Turn off the engine and wait for a couple of minutes. Then pull out the dipstick for the transmission to check the oil level. If the oil is half way up the dipstick the transmission fluid is likely not the problem.
What does the 4 wheel drive light mean?
The purpose of the 4 wheel drive light is to indicate when you have engaged 4WD mode by selecting 4H. When the light flashes continuously for more than 30 seconds it signifies there is a problem somewhere on your drivetrain system and that 4WD has not engaged properly.