Does a 4L60E need to be programmed?
On the 4L60E, however, it is strictly a PCM programming function. You may be able to hold gears down by using the shifter, but you cannot cause the up-shifts to occur before the PCM commands it. In the 4L60E the up-shifts are completely controlled by the PCM. The 4L60E can only do what it’s told.
How much does a rebuilt 4L60E transmission cost?
Cost of Having a shop Rebuild the 4L60E If you plan on having the shop rebuild it, and you pull and bring the transmission to them, it’s possible to have it done for $1000 or under. Not much under, though. If you have a shop pull, rebuild, and reinstall the transmission it can cost anywhere from $2000-$4000.
Can a transmission be rebuilt in one day?
So how long does it take to rebuild a transmission? Most people need their cars running again as soon as possible. This can depend though, it can be done in as little as one day although the average is usually between three to four days.
How do I reset my 4L60E transmission?
Steps to Resetting Transmission Control Module
- Step 1: Turning Key Position. Before resetting the transmission control module, it is necessary to check the key position.
- Step 2: Press gas pedal.
- Step 3: Keep Waiting.
- Step 4: Turning the Key Off.
- Step 5: Releasing Gas Pedal.
- Step 6: Wait Again.
- Step 7: Ready.
How long do 4L60E transmissions last?
Re: what are the max miles on 4l60e transmission before fail I have close to 300k on my truck back in the day before I sold it. 4l60e from 1996 held up well. Reverse kinda was finicky, every now and than it would slip but had a good life. I honestly think around 250-300k it should be rebuilt if its original.
Is a 4L60E interchangeable with a 4L80E?
FYI – 4L60E & 4L80E transmissions are NOT directly interchangeable. The wiring pinout of the trans plug is different, and 2 VSS’s are used versus 1 on the 4L60E. Besides the wiring difference, the ECM also requires a segment swap as that portion of the transmission control is completely different.
How many solenoids are the 4L60E?
There are 2 shift solenoids in a 4l60e (1-2 and 2-3), and both control up and downshifts with fluid passing through them when commanded to do so by the computer. However, when they go bad, you will notice very quickly. Your transmission will display a variety of symptoms, but sometimes these issues can be confused by other common 4l60e issues.
What does the E stand for in 4L60E?
4L60E Identification. The 4L60E transmission has been in production for over twenty years, even longer if you consider the fact that it came from the 4L60 (700R4). The 4L60 got the E at the end whenever control of the transmission was switched to the engine computer. The E stands for “electronic” or electronic shift.
What is the length of a 4L60E?
The 4L60E has a weight of 150 lbs without fluid and the length of 23.5″, while the 4L80e have the weight of 236 lbs and the length of 26.4″. Just with these number, you can probably calculate that there is a big difference in size and weight between these transmissions.